JVC HM-DH30000U DBS Receiver Brand Setting, 68 EN, Turn on the DBS receiver, Operate DBS receiver

68 EN MULTI-BRAND REMOTE CONTROL (cont.)

DBS Receiver Brand Setting

23–13

VCR TV CABLE/DBS			POWER
			ENTER
1	2	3	3–2
4	5	6
7	8	9	Number
	0

This Remote can control some functions of the DBS (Direct Broadcast Satellite) receivers listed below.

1 Turn on the DBS receiver

Turn on the DBS receiver using the Power button on the DBS receiver or its Remote.

2 Set remote operation mode

Set the VCR/TV/CABLE/DBS selector to “CABLE/ DBS”.

3Enter DBS receiver brand code

Follow the example shown below.

1Press and hold POWER.

2Press the Number keys to enter your DBS receiver’s brand code by referring to the table

below.

3Press STOP ( 7 ), and release POWER.

●Once you have set the Remote to operate the DBS receiver, you do not have to set it until you replace the batteries from the Remote.

3–3

TV CH +/–

DBS BRAND NAME	BRAND CODE
JVC (DISH Network)	51
ECHOSTAR (DISH Network)	51
PRIMESTAR	50
SONY (DSS)	41
RCA (DSS)	40

4 Operate DBS receiver

First set the VCR/TV/CABLE/DBS selector to “CABLE/DBS”, then press one of the following buttons: POWER, TV CH +/–, and Number keys.

●For some brands, you must press ENTER after having pressed the Number keys to enter a channel number.

●To change the DBS receiver’s channels, press TV CH +/– or the Number keys. (The CH +/– button can be used to change the VCR’s channels only.)

●To operate the VCR, set the VCR/TV/CABLE/ DBS selector back to “VCR”.

NOTES:

●Depending on the type of DBS receiver, some or all functions cannot be operated using this Remote.

●It’s not possible to operate a DBS receiver not equipped with a remote sensor.

●It's not possible to set the Remote for both your DBS receiver and a cable box at the same time. You can only set the Remote to operate one of these units at a time.

(Ex.) To set the Remote to JVC 51:

POWER	1
5		STOP
JKL	. , ?

Hold Press in succession Release

down