JVC HM-DH30000U 20 EN, Enter DBS Receiver’s brand, AccessPress OKDBS. Receiver Brand Set screen

20 EN INITIAL SETTINGS (cont.)

VCR TV CABLE/DBS

1	2	3
4	5	6	7
7	8	9
	0

@ #

67

OK

NOTES:

●The Controller may not work with all types of DBS receiver.

●If your DBS receiver does not respond to the code, you cannot use the Controller to change satellite channels. In this case, make sure to leave the DBS receiver turned on and tuned to the proper channel before the scheduled start time of timer recording. In addition, if your DBS receiver is equipped with a timer, you can also use “Satellite Auto Recording” (☞ pg. 60).

●The VCR can only change the satellite channel through the Controller during timer recording.

●If your DBS receiver cannot be operated with a remote control (because it has no remote sensor), you cannot use the Controller to change its channels. Make sure to leave the DBS receiver turned on and tuned to the proper channel before the scheduled start time of timer recording.

●For customers in U.S.A.: If you are unable to set the Controller, contact JVC toll free at 1-800-252-5722.

6AccessPress OKDBS. Receiver Brand Set screen

	Enter DBS Receiver’s brand
7 Press the appropriate		DBS RECEIVER BRAND SET
	Number keys to enter
	the brand code from the			4 0
	following list, then
	press OK.
	The program currently	PRESS NUMBER KEY (0–9)
		THEN (OK) TO TEST
	received through the
		PRESS (MENU) TO END
	DBS receiver appears
	for about 10 seconds.
	BRAND			CODE
	JVC (DISH Network)		51
	ECHOSTAR (DISH Network)		51
	PRIMESTAR		50
	SONY (DSS)		41
	RCA (DSS)		40

●If the DBS receiver’s channel changes to the channel listed below for your brand, setting is complete

JVC = 100 ECHOSTAR = 100 PRIMESTAR = 55 SONY = 205 RCA = 205

Press OK and “DBS	DBS RECEIVER BRAND SET
RECEIVER CONTROL	51
IS ON” appears on the
	DID YOUR DBS RECEIVER
screen for about 5
	CHANGE TO CHANNEL 205?
seconds, then it
	2	YES	3 NO
returns to the normal
	PRESS (2 3), THEN (OK)
screen.	PRESS (MENU) TO END

●If the DBS receiver’s

channel does not change as shown above

1 Press @ # to move the highlight bar to “NO”. 2 Press OK.

3 Re-enter the correct code.