JVC HM-DH30000U manual Express Timer Programing, 38 EN, Set program stop time, Set program date

38 EN TIMER RECORDING (cont.)

Express Timer Programing

Turn on the VCR and the TV, and select the AV mode on the TV.

1

You can directly program the VCR’s timer to record up to 8 broadcasts, as far as a year in advance. Remember, the clock must be set before you can program the timer (☞Ê pg. 10).

1 Load a cassette

Make sure the record safety tab is intact. If not, cover the hole with adhesive tape, then load it into the VCR.

●The VCR turns on, and the counter is reset, automatically.

2Access VCR PLUS+ screen

Press PROG..

	Access Program screen
3 Press START +/– once.			PROGRAM
			START	STOP	DATE
			– –:– –AM	– –:– –AM	– –/– –/– –
			CH		SUN
			– – –	STD (SP)
		PRESS (+/–, SP/EP, 8=DAILY
		9=WEEKLY) THEN (OK)
		PRESS (PROG.) TO END
	Set program start time
4 Press START +/–			PROGRAM

VCR TV CABLE/DBS

DAILY (M-F)

DBS

12

78

POWER

3

6

9 WEEKLY

repeatedly to enter the		START	STOP	DATE
time you want
		8:00AM	– –:– –AM	– –/– –/– –
recording to start.		CH		SUN
		– – –	STD (SP)
● Press and hold START	PRESS (+/–, SP/EP, 8=DAILY
+/– to increase the
	9=WEEKLY) THEN (OK)

time in 30-minute	PRESS (PROG.) TO END
intervals.

0	0
3–7

8

29

9

5 Set program stop time

Press STOP +/– repeatedly to enter the time you want recording to stop.

●Press and hold STOP +/– to increase the time in 30-minute intervals.

6 Set program date

Press DATE +/–. (The current date is displayed on the screen. The date you enter appears in its place.)

7 Set channel number Press CH +/–.

●If you are using a DBS receiver, see “ATTENTION FOR DBS RECEIVER USERS” on next page.

●Holding down CH +/– rapidly changes the channel numbers.