JVC HM-DH30000U manual Load cassettes, Select input mode on recording VCR, Select edit mode

EN 65

VCR TV CABLE/DBS

2

3

Load cassettes

Insert the playback cassette into the playback VCR and the cassette to be recorded on into the recording VCR.

Select input mode on recording VCR

Select the correct external input on the other VCR.

1	2	3
4	5	6
7	8	9
	0	3
		3

4

●On this VCR (when using this VCR as the recording VCR);

L-1 or L-2 — when connecting the other VCR to the audio/video input connectors or the rear panel.

F-1 — when connecting the other VCR to the audio/video input connectors on the front panel.

I-1 etc. — when connecting the other VCR to i.LINK IN/OUT connector.

Press the Number key “0 (AUX)” or CH +/–.

NOTES:

●When using this VCR as the recording VCR, set the video input terminal setting correctly (☞ pg. 63).

●When using this VCR as the playback VCR for editing, set “DIGITAL R3” to “OFF” (☞ pg. 53).

Select edit mode

Set the edit mode to “ON” for the VCRs if such a mode is equipped.

●On this VCR, set “PICTURE CONTROL” to “EDIT” (☞ pg. 53).

5Start playback

Press PLAY ( 3 ) on the playback VCR.

NOTE:

If the playback VCR is equipped with a superimpose/ OSD disable feature then set it to “OFF” before starting playback (☞ pg. 56).

6Start recording

Press REC ( ¦ ) on the recording VCR.

NOTES:

●Be sure to select “AUTO” for “PICTURE CONTROL” (or “NORM” when “V, CALIBRATION” is set to “OFF”) after you finish dubbing the tapes (☞ pg. 53).

●When dubbing using the i.LINK connector, set the recording speed on the recording VCR to the same speed as the source tape on the playback VCR.