JVC HM-DT100U S-VIDEO/VIDEOConnections, 82 EN, EDITING (cont.), Connection with the camcorder, AConnection with the camcorder, Various connection for editing tapes

82 EN EDITING (cont.)

S-VIDEO/VIDEO Connections

Various connection for editing tapes

The following three methods can be used for editing tapes.

•VHS to S-VHS editing (VIDEO-VIDEO connection):

Although the picture quality is inherently limited by the original VHS quality, the edited tape has better picture quality than those made by VHS-to-VHS editing.

•S-VHS to VHS editing (VIDEO-VIDEO connection):

Since the original source is recorded in S-VHS mode, the edited tape has better picture quality than those made by VHS-to-VHS editing.

•S-VHS to S-VHS editing (S-VIDEO connection):

Original picture quality of S-VHS made can be duplicated with minimal picture degradation. This is the best editing method you can use on S-VHS VCRs.

AYou can use a camcorder as the playback device and your VCR as the recording VCR.

This VCR (for recording)

IN F–1

To [AUDIO]	To rear panel
input	[REMOTE PAUSE/AV
	COMPULINK]

To [S-VIDEO] input

Audio cable (supplied)

Mini-plug cable (not supplied)

S-video cable (JVC camcorder only) (supplied)

To Audio output

To EDIT

To S-video output

DV camcorder (for playback)

BYou can use your VCR as the playback or recording VCR.

E.g. When using this VCR as the recording VCR

This VCR (for recording)

i.LINK IN/OUT	HDMI OUT OPTICAL	S-VIDEO	S-VIDEO		ATSC IN
DV IN
S400
D-THEATER	PCM/STREAM				VHF/UHF
REGION 1		VIDEO		VIDEO	ANTENNA
	DIGITAL AUDIO OUT
	Y				IN
	PB/CB	L		L
		AUDIO		AUDIO	CABLE BOX
	PR/CR	R		R	OUT
	COMPONENT		L-1	L-2	ANTENNA
		OUTPUT	INPUT		REMOTE PAUSE/
	VIDEO OUT
					AV COMPULINK

	To [AUDIO	To [S-VIDEO
	INPUT]	INPUT]
	Audio cable	S-video cable
	(supplied)	(supplied)
To AUDIO	To S VIDEO
output	output

Another VCR (for playback)

NOTE:

When using this VCR as the playback VCR,

During playback, if the images cannot be displayed on the TV, press [HDMI] on the front panel to turn off the [HDMI] LED and set “TV OUTPUT 2” to “ALLto480i” (A page 67). In event when even the main menu screen cannot be displayed on the TV when [MENU] is pressed, power off this VCR, press and hold [PAUSE (W)] for more than 5 seconds, then power on the VCR again.

A Make connections

AConnection with the camcorder

Connect an audio/S-video cable between the camcorder’s audio/S-video output connectors and your VCR’s [AUDIO/S VIDEO] input connectors.

•When the JVC camcorder is equipped with the Master Edit Control, you can control the VCR from the camcorder. Connect the mini- plug cable (not supplied with this VCR) as illustrated on the left.

•When using a camcorder with a monaural output, connect the audio output connector on the camcorder to the [AUDIO L] input connector on this VCR.

NOTE:

If the camcorder does not have S-video output connector, use a video cable.