EN 27
E Enter DBS Receiver’s brandVCR CABLE TV /DBS
Press [FG] to move the arrow to “BRAND”.
Press [D E] to enter the brand code from the following list.
FUNCTION SET UP TUNER SET UP | INITIAL SET UP | |||
| DBS SET UP |
|
|
|
|
|
|
|
|
| INPUT CH |
| OFF | |
|
| |||
| BRAND |
|
| |
|
| 40 |
|
TEST MODE
G
NOTES:
MENU | OK | SELECT WITH ARROW KEYS |
EXIT | SELECT | THEN PRESS [OK] |
|
BRAND | CODE |
JVC (DISH Network) | 51 |
ECHOSTAR (DISH Network) | 51 |
SONY (DSS) | 41 |
RCA (DSS) | 40 |
F Engage test mode
Press [FG] to move the arrow to “TEST MODE”, then press [OK].
The program currently received through the DBS receiver appears for about 10 seconds.
NOTE:
If you do not engage the test mode in step F, “INPUT CH” and “BRAND” are not set.
•If the DBS receiver’s channel changes to 205, setting is completePress [D E] to | FUNCTION SET UP TUNER SET UP INITIAL SET UP | ||
move the arrow to |
|
|
|
| DBS SET UP |
| |
“YES”, then press |
|
|
|
|
|
|
•The Controller may not work with all types of DBS receiver.
•If your DBS receiver does not respond to the code, you cannot use the Controller to change satellite channels. In this case, make sure to leave the DBS receiver turned on and tuned to the proper channel before the scheduled start time of timer
recording. In addition, if your DBS receiver is equipped with a timer, you can also use ‘Satellite Auto Recording’ (A page 47).
•The VCR can only change the satellite channel through the Controller during timer recording.
•If your DBS receiver cannot be operated with a Remote (because it has no remote sensor), you cannot use the Controller to change its channels. Make sure to leave the DBS receiver turned on and tuned to the proper channel before the scheduled start time of timer recording.
•For customers in U.S.A.: If you are unable to set the Controller, contact JVC toll free at
|
| INPUT CH | OFF |
[OK] and “DBS |
| DID YOUR DBS RECEIVER CHANGE TO | |
RECEIVER |
|
| CHANNEL 205? |
| YES | NO | |
CONTROL IS ON” |
|
|
|
appears on the | MENU | OK | SELECT WITH ARROW KEYS |
|
| ||
screen for about 5 | EXIT | SELECT | THEN PRESS [OK] |
| |||
|
|
|
seconds
•If the DBS receiver’s channel does not change as shown aboveA Press [D E] to move the arrow to “NO”. B Press [OK].
C
G Return to normal screen
Press [MENU].