Access Video Channel SET Mode, SET Video Channel

	PROG	STOP
2	TV	1
2

1 2 3

4 5 6

7/ 8 9

0 4

TV PROG 2

1 3 Á

¦ 7 8

1	4	¢
	4	¢
	3

3 OK

IMPORTANT:

Before performing the following steps, make sure the recorder's power is off and there is no cassette inserted in the recorder.

With AV Connection

ACCESS VIDEO CHANNEL

SET MODE

	Press and hold down STOP on the recorder until the
1		display panel shows the following.
1

2	SET VIDEO CHANNEL
	Press TV PROG – until the display panel shows
	"–OUT– –".

●Now the video channel is set to off.

EXIT VIDEO CHANNEL SET

MODE

3	Press OK.
4	TURN OFF THE RECORDER
	Press	.

To view picture signals from the video recorder, set your TV to its AV mode.

After you finish this step, go to "Auto Set Up" on page 8.

Page 7

Image 7

JVC HR-DD445EK Access Video Channel SET Mode, SET Video Channel, Exit Video Channel SET Mode, With AV Connection

Contents

HR-DD445EK Do not place the recorder Safety Precautions Some Dos And Donts On The Safe Use Of Equipment Connect Recorder to Mains Check ContentsBasic Connections Situate Recorder Back of Recorder TV Aerial Cable not provided With RF Connection Video Channel Set With AV Connection Access Video Channel SET ModeExit Video Channel SET Mode SET Video Channel Perform Auto SET UP Auto Set Up If auto channel set has succeeded but auto clock set has not Screen Video Plus+ SetupMake List of Stored Station Names Preset Positions Access Main Menu Back Confirm Preset Position NumberWhen Using a Satellite Receiver And/Or Cable System Close Menu Start Playback Basic PlaybackLoad a Cassette Point Activate SLOW-MOTION Playback FeaturesPause During Playback Playback Activate Instant Review Adjust Tracking ManuallyOverride Automatic Tracking Return to Automatic Tracking Memory Activate RepeatSET Counter Memory Activate Counter Variable-Speed Search TimeScanActivate HIGH-SPEED Search High-Speed Search TimeScan Audio TimeScanSpeed SP Speed LP Audio output Basic Recording Recording Features Return to Normal S.T. Picture SystemRecording Playback PDC Recording Video Plus+ Timer Recording Press OK after entering If your recorder receives Start Time Regular Timer ProgrammingTime Engage RECORDER’S Timer ModePress TV Prog + Press Prog Check Check And Cancel ProgrammesTimer Warning Revise Programme Information Auto Timer Start Source Player SET Recording DECK’S Input ModeEdit To Or From Another Video Recorder Make Connections Start Recorder SET RECORDER’S Input ModeEdit From a Camcorder Start Camcorder Satellite Receiver Unit Connection To a Satellite Receiver Pin Scart connectors Aerial terminal Turn on the Recorder Access Main Menu ScreenAccess Mode SET Screen ENABLE/DISABLE ON-SCREEN Display End Tape Position Indicator Perform Auto Channel SET Auto Channel Set Located appear on a Preset positions PRProcedures Stations your recorder Manual Channel Set Select NEW Position Change Station Preset PositionSelect Item Delete Channel Enter NEW Character Switch StationsSelect NEW Station Select Station Name Character FINE-TUNE Perform TuningFine-Tuning Channels Already Stored Select Channel to TV Station And ID List Bluebell Hill TV Station Channel Number GuideChannel Islands Turn the Recorder on Clock SetPreparation SET Just Clock PresetSET Clock SET Date and Time If you are using the AV connection Panel with Auto Timer set to OFF Indicator offClear Won’t stop Timer again Questions and Answers Maximum recording time Specifications Index Rear View Remote Control Prog +/-, TV VOL +/-, TV Mute Installing BatteriesHow To Use Operating JVC TVs Victor Company of JAPAN, Limited