JVC HR-DD855EK setup guide TimeScan Audio, Speed SP Speed LP Audio output

21

TimeScan

Names of special-effects playback

Speed SP

Speed LP

Audio output

Reverse

Forward

Search

Play

Slow-Motion

*Still

Slow-Motion

Play

Search

-9x

-7x

-5x

-3x

-1x

-1/6x

-1/18x

0

1/18x

1/6x

1x

2x

3x

5x

7x

9x

-7x

-3x

-1/6x

-1/18x

0

1/18x

1/6x

1x

2x

5x

9x

Audio is output.

Audio is not

Audio is

Audio is not

Audio is output.

output.

output.

output.

* To activate the Still mode from the remote control press PAUSE button. Still mode cannot be engaged using the remote control's Þ%button.

●The speed is shown during TimeScan in the upper right corner of the TV screen for approx. 5 seconds. (On some TVs the display may be distorted.)

●To resume normal playback, press PLAY.

●When using the recorder's TIME SCAN SHUTTLE ring, the playback speed may not change in the correct step if it is turned too fast.

●Picture and audio may occasionally become distorted when the recording speed changes. If this happens, resume normal playback once, and then try using TimeScan again.

●The picture may be noisy or there may be a loss of colour when you change the playback speed. (More noise will appear with LP recordings.)

●Noise may appear or the upper part of the picture may be distorted during still, frame-by-frame playback, 2x search of LP recordings, or with certain tapes.

●Picture may appear distorted in comparison to normal playback.

●In TimeScan mode there will be a time lag between the video and the audio and noise may appear in the audio signal.

●TimeScan sound quality will differ in comparison to normal playback.

●When material such as music videos where there is non-stop sound (very few breaks in the soundtrack) are viewed at 2x normal speed, the audio playback may be faster than normal.

●When the playback direction is reversed, it takes approximately 6 seconds until sound is heard.

●When playing back an NTSC tape, the speeds differ from those listed above and are not shown on the TV screen.

Also, depending on the type of tape being used, the picture may be distorted and there may be a loss of colour even when in the TimeScan mode.

If you don't want to hear TimeScan audio, set the "TIME SCAN AUDIO" to OFF. (See below)

TimeScan Audio

The audio output can be set ON/OFF during TimeScan. Select ON/OFF as required.

MODE SET

1Press MENU to access the Main Menu screen.

2Move the highlight bar (pointer) to "MODE SET" by pressing %Þ, then press OK.

3Move the highlight bar (pointer) to "TIME SCAN AUDIO" by pressing %Þ, then press select "ON" or "OFF".

4Press MENU to return to the normal screen.

%

to

AUTO TIMER	OFF
O. S. D.	ON
B.E.S.T.	OFF
AUTO SP=LP TIMER	OFF
TIME SCAN AUDIO	ON
[5°] =
[MENU] : EXIT