30 EN
123
456
789
0
2
4
1

EDITING

Edit ToAnother VideoRecorder
You can use your video recorder as the source player and
another video recorder as the recording deck.

MAKE CONNECTIONS

1
Connect the player’s AUDIO/VIDEO OUT connectors
to the recorder’s AUDIO/VIDEO IN connectors.

SET RECORDING DECK’S

INPUT MODE

2
Set the recording deck's external input mode.

START SOURCE PLAYER

3
Press PLAY on the source player.

START RECORDING DECK

4
Engage its Record mode.
NOTES:
●
All necessary cables can be obtained from your dealer.
●
If you do not want to record the superimposed indication on
the editied tape, be sure to set "O.S.D." to "OFF" before you
start editing (
Z
pg. 10).
Another recorder
Recording deck
RF Cable (provided)
VIDEO
CHANNEL
Your recorderSource playerTV Receiver
AV Cable
(not provided)
Remote A/B Code
Switching
The remote control is capable of controlling two JVC video
recorders independently; one set to respond to the remote
control’s A code control signals and another set to respond to
B code control signals. The remote control is preset to send A
code signals because your video recorder is initially set to
respond to A code signals. You can easily modify your video
recorder to respond to B code signals.
PLAY
1Unplug the mains power cord from the mains outlet.
2While holding down VCR on the remote control, press the
NUMBER key "2" and then press STOP.
3Plug the mains power cord back into the mains outlet.
4Press on the remote control. The recorder will now
only respond to B code signals.
NOTE:
To set the recorder back to respond to A code signals, repeat
the same procedure as shown above except pressing
NUMBER key "1" instead of "2" in step 2.
NUMBER "2"
NUMBER "1"
VCR
STOP