JVC HR-J259EE, HR-J459EE specifications Start Auto Channel SET, Press Menu Auto SET screen, Appears

TV PROG

EN7

START AUTO CHANNEL SET

Press MENU and the
"AUTO SET" screen		AUTO SET
6 appears. When Auto
Channel Set is completed,		PLEASE WAIT
"SCAN COMPLETED"
appears for about 5	0	+	+	+
seconds on the screen,
then the normal screen	[MENU] : EXIT
appears.

●The Auto Set Up function scans all the channels that are receivable by your recorder. It then automatically assigns each receivable channels to the TV PROG buttons. It skips non-receivable channels.

●As Auto Set Up progresses, the " " mark on the screen moves from left to right.

ATTENTION

1 2 3

4 5 6

7 8 9

0

1

3

MENU

2

4

TV PROG

OK

Since the product is designed for use in regions where the D/K TV system is used, Auto Set Up will not work properly in regions where the B/G TV system is used (☞ pg. 34).

Please set the tuner manually (☞ pg. 34).

NOTES:

●If you perform Auto Set Up when the aerial cable is not connected properly, "SCAN COMPLETED -NO SIGNAL-" appears on the screen. When this happens, make sure of the aerial connection and press OK; Auto Channel Set will take place again.

●If there is a power cut, or if you press or MENU while Auto Set Up is in progress, Auto Channel Set will be inter- rupted; be sure to turn off the recorder power once and try again.

●If you want to set the tuner manually such as to add or skip channels, to swap channel positions, or to fine-tune channels, ☞ pg. 34 – 35.

●If no sound accompanies the picture on some channels that have been stored by Auto Set Up, the TV system setting for those channels may be incorrect. Select the appropriate TV system for those channels. ☞ "TV System Selection – When you see the picture but hear no audio" on page 37.