JVC HR-J642U manual Timer again, Resume recording Even though Auto or Semi-Auto

								E	N	39
TIMER RECORDING
		SYMPTOM			POSSIBLE CAUSE		CORRECTIVE ACTION
1. Timer recording won’t work.			● The clock and/or the timer have			Set the clock and/or timer correctly.
				been set incorrectly.
			● The timer is not engaged.			Press TIMER and check to make sure
						that TIMER appears on the front
						display panel.
			● The VCR has not been set up properly.			Re-perform the set-up procedures.
2.	On-screen timer programming		● Timer recording is in progress.			Timer programming can’t be performed
	won’t work.					when timer recording is in progress.
						Wait until it finishes.
3. TIMER and ]on the front			● The timer is engaged but there’s no			Load a cassette with the record safety
	display panel won’t stop blinking.			cassette loaded.		tab intact, or with the hole covered
						with adhesive tape.
			● The loaded cassette has had its			Press TIMER so that TIMER on the
				record safety tab removed.		display panel disappears, then eject
						the cassette and cover its hole with
						adhesive tape, or replace it with a
						cassette on which the safety tab is
						intact.
4.	TIMER blinks for 10 seconds and		● TIMER has been pressed when there			Check the programmed data and re-
	the timer mode is disengaged.			are no programs in memory, or the		program as necessary, then press
				timer record program information		TIMER again.
				has not been programmed correctly.
5. The cassette is automatically			● The end of tape was reached during			The program may not have been
	ejected, the power shuts off and			timer recording.		recorded in its entirety. Next time
	TIMER and ]won’t stop					make sure you have enough time on
	blinking.					the tape to record the entire program.
OTHER PROBLEMS
		SYMPTOM			POSSIBLE CAUSE		CORRECTIVE ACTION
1.	When scanning channels, some of			● Those channels have been preset to		If you need the skipped channels,
	them are skipped over.			be skipped.		restore them (☞ pg. 14).
2.	The channel can’t be changed.			● Recording is in progress.		Press PAUSE to pause the recording,
						change channels, then press PLAY to
						resume recording.
3.	Even though Auto or Semi-Auto			● The clock setting data received from		Select a different Host Channel during
	clock setting has been selected, the			the Host Channel is incorrect.		the Semi-Auto setting procedure
	clock is incorrect.					(☞ pg. 10), or perform the Manual
						setting procedure (☞ pg. 11).

ATTENTION:

This VCR contains microcomputers. External electronic noise or interference can cause microcomputer to malfunction. If the VCR does not operate correctly switch its power off and unplug the power cord from the AC supply. Wait for a while and then plug the power back in. Eject and check the condition of the cassette. If everything appears normal resume operating the VCR as usual.