JVC HR-J7004UM manual Turn On The Satellite Receiver, Enter Satellite Receiver Brand, Brand Code

38

SPECIALFEATURES(cont.)

	Satellite Receiver Multi-
	Brand Remote Control
POWER	The VCR's remote control can control functions on the brands
	of satellite receivers listed below.

	1	2	3
NUMBER	4	5	6
	7	8	9
		0

CH

TV/CABLE/VCR

STOP

1

2

3

4

TURN ON THE SATELLITE RECEIVER

Turn the power on using the satellite receiver’s remote control.

SET REMOTE CONTROL MODE

Set the TV/CABLE/VCR switch on the VCR’s remote control to CABLE.

ENTER SATELLITE RECEIVER BRAND

While holding down POWER on the VCR's remote control, use the NUMBER keys to enter the satellite receiver brand number from the chart below and then press STOP.

Follow the example shown at bottom left.

●Once you have set the remote control to operate the satellite receiver, you don't have to repeat this step until you replace the remote control's batteries.

OPERATE SATELLITE

RECEIVER

First, press POWER to see if the satellite receiver’s power goes off as it should. If it does, try other functions (CH5° and the NUMBER keys can be used to operate the satellite receiver).

●For some brands of satellite receiver, you must press ENTER after having pressed the NUMBER keys.

●To return the remote to VCR control, set the TV/ CABLE/VCR switch to VCR.

NOTES:

●Depending on the kind of satellite receiver, there may be cases where some or all functions cannot be operated using the remote control.

●It's not possible to set the remote control for both your cable box and your satellite receiver at the same time; you can only set the remote control to the brand of either one.

●You have to subscribe to a satellite broadcaster to receive satellite channels.

(Ex.) To set remote control to RCA 80:

POWER		STOP
8	0		Release
Hold	Press in succession
down

SATELLITE BRAND NAME	BRAND CODE
RCA (DSS)	80
SONY (DSS)	81
PRIMESTAR	90