JVC HR-J7004UM manual Turn On The Tv, Set Remote Control Mode, Set Tv Brand Code, Operate Tv

36

SPECIALFEATURES

TV Multi-Brand Remote

Control

POWER

The VCR's remote control can control several functions on JVC remote control TVs and on the brands of remote control TVs listed below.

	1	2	3	ENTER
NUMBER	4	5	6
	7	8	9

0

CH

TV VOL. +/–

TV/CABLE/VCR

TV/VCR

STOP

TV BRAND NAME	BRAND CODE
JVC	01
GRADIENTE	02, 11, 12, 16
PHILIPS	03
CCE	03
SANYO	04
PHILICO/HITACHI	05
SHARP	06
TOSHIBA	07
MITSUBISHI	08
PHILICO/DAEWOO	09
SAMSUNG	10
GOLDSTAR	11
RCA	12
PANASONIC	13
GRUNDIG	14
SONY	15
NEC	16
PHILICO	17
NOBLEX	18

TURN ON THE TV

1 Turn the power on using the TV's remote control.

SET REMOTE CONTROL MODE

2 Set the TV/CABLE/VCR switch on the VCR's remote control to TV.

SET TV BRAND CODE

3 Refer to the chart below. While holding down POWER on the VCR's remote control, enter your TV’s brand code using the NUMBER keys, then press STOP. Follow the example shown at bottom left.

●Once you have set the remote control to operate the TV, you don’t have to repeat this step until you replace your remote control’s batteries.

●GRADIENTE has four codes. If the TV does not function with one code, try entering another.

OPERATE TV

4 First, press POWER on the remote to see if the TV’s power goes off as it should. If it does, try other operations.

●The POWER, TV/VCR, CH5°, TV VOL. +/– and NUMBER keys on the remote can all be used to operate the TV. *For some brands of TV, you must press ENTER after having pressed the NUMBER keys.

●If you have a JVC TV equipped with Hyper Surround or Live Effex, the button may work to operate it.

●To return the remote to VCR control, set the TV/ CABLE/VCR switch to VCR.

NOTE:

Depending on the kind of TV, there may be cases where some or all functions cannot be operated using the remote control.

(Ex.) To set remote control to PHILIPS 03:

POWER		STOP
0	3		Release
Hold	Press in succession
down