Yamaha RX-V2700 Changing source names in the display window, 114 En, Other remote control

REMOTE CONTROL FEATURES

5Press and hold the button you want to program on the other remote control until “OK” appears in the display window on the remote control.

“NG” appears in the display window on the remote control if learning was unsuccessful. In this case, start over from step 4.

		V
		-	PHONO			POWER
	DTV	AUX/DOCK			TV
	VCR 1	CBL/SAT	TUNER	NET/USB	AV	POWER
	DVR/VCR 2	MD/TAPE	CD	AUDIO SEL		STANDBY
SELECT	DVD	CD-R	MULTI CH IN	SLEEP		POWER

Other remote control

y

Changing source names in the display window

You can change the name of the input source that appears in the display window on the remote control if you want to use a different name than the factory preset. This feature is useful when you have set an input area to control a different component.

1Set the operation mode selector to AMP or SOURCE and then press an input selector button or to select the input area you want to rename.

The name of the selected input area appears in the display window.

AMP
SOURCE		NET/USB
TV	PHONO	TUNER	CD	MULTI CH IN

•If you want to program another function, repeat steps 4 and 5.

•If you continuously want to program another function for another component, press SELECT k / n to select the

component, and then repeat steps 4 and 5.

or

AMP

SOURCE

TV

V-AUX/DOCK CBL/SAT MD/TAPE CD-R

DTV VCR 1 DVR/VCR 2 DVD

6Press LEARN again to exit the learning mode.

LEARN

Notes

•“ERROR” appears in the display window on the remote control if you press a button not indicated in the respective step, or when you press more than one button simultaneously.

•This remote control can learn approximately 200 functions. However, depending on the signals learned, “FULL” may appear in the display before you program 200 functions. In this case, clear unnecessary programmed functions to make room for further learning.

•Learning may not be possible in the following cases:

–when the batteries in the remote control for this unit or other components are weak.

–when the distance between the two remote controls is too great or too small.

–when the remote control infrared windows are not facing each other at the appropriate angle.

–when the remote control is exposed to direct sunlight.

–when the function to be programmed is continuous or uncommon.

2Press RENAME using a ballpoint pen or similar object.

RENAME

Note

If you do not complete each of the following steps within 30 seconds, the renaming mode will be automatically canceled. In this case, start over from 2.

114 En