Yamaha RX-V2700 owner manual Using Auto Setup, 35 En

AUTO SETUP

This unit employs the YPAO (YAMAHA Parametric Room Acoustic Optimizer) technology which lets you avoid troublesome listening-based speaker setup and achieves highly accurate sound adjustments automatically. The supplied optimizer microphone collects and this unit analyzes the sound your speakers produce in your actual listening environment.

Using Auto Setup

Once you have connected the supplied optimizer microphone to the OPTIMIZER MIC jack on the front panel and have placed it in a suitable location in your listening room, run “Auto Setup” in the GUI screen.

Notes

•Connect a video monitor to run “Auto Setup” (see page 23).

•Be advised that it is normal for loud test tones to be output during the “Auto Setup” procedure.

•To achieve the best results, make sure the room is as quiet as possible while the “Auto Setup” procedure is in progress. If there is too much ambient noise, the results may not be satisfactory.

1Connect the supplied optimizer microphone to the OPTIMIZER MIC jack on the front panel.

AUDIO	TONE	REC OUT/				PRESET/	FM/AM	MEMORY	TUNING	ENHANCER NIGHT
SELECT	CONTROL	ZONE2	A/B/C/D/E	PRESET/TUNING		TUNING		MAN'L/AUTO FM	MODE
						EDIT
			STRAIGHT				ZONE ON/OFF ZONE CONTROLS
					MULTI ZONE
			EFFECT				ZONE 2	ZONE 3
			YPAO	SILENT CINEMA	S VIDEO	VIDEO	L AUDIO R		OPTICAL
	PROGRAM		OPTIMIZER	PHONES		VIDEO AUX				USB
			MIC

Omni-directional microphone

PREPARATION

y

• If an error occurs during the “Auto Setup” procedure and an

error or warning message appears in the GUI screen or in the
	2 Place the optimizer microphone at your
front panel display, see the “Auto Setup” section in
“TROUBLESHOOTING” on pages 138 and 139 for a complete	normal listening position on a flat level
list of error and warning messages and proper remedies.	surface with the omni-directional
• The initial setting for each parameter is indicated in bold.
	microphone heading upward.
• If the volume level and the crossover frequency of your
subwoofer can be adjusted, set the volume level to about half		Optimizer microphone
way (or slightly less) and set the crossover frequency to the
maximum.

+	+
TV VOL	CH
–	–
TV MUTE	TV INPUT
LEVEL	PRESET/CH
TITLE
	ENTER
RETURN
MEMORY

AMP

+

SOURCE

VOLUME

–TV

MUTE

SET MENU PURE DIRECT

MENU

SRCH MODE

AUDIO

A/B/C/D/E

STRAIGHT

DISPLAY

EFFECT

4

4,13

5-12

y

It is recommended that you use a tripod (etc.) to affix the optimizer microphone at the same height as your ears would be when you are seated in your listening position. You can use a 6

mmdiameter screw to fix the optimizer microphone to a tripod (etc.).

English

35 En