Yamaha RX-V2700 owner manual 124 En, Adjusting the volume level of Zone 2 or Zone

USING MULTI-ZONE CONFIGURATION

INPUT

or

		NET/USB
AMP
	PHONO	TUNER	CD	MULTI CH IN
SOURCE	V-AUX/DOCK	CBL/SAT	MD/TAPE	CD-R
TV	DTV	VCR 1	DVR/VCR 2	DVD

Select TUNER as the input source to use the TUNER features in the selected zone. For details about the TUNER operations, see “FM/AM TUNING” on page 56.

Note

The selected input source is shared across all zones.

y

•You must complete this step within 5 seconds while the selected zone flashes in the front panel display. Otherwise, the currently selected zone mode is automatically canceled. In this case, press ZONE CONTROLS on the front panel again.

•When a video monitor is connected to one of the ZONE VIDEO jacks, you can display the control information of Zone 2 or Zone 3 on the video monitor screen. Set “Zone OSD” to “Zone2&Zone3” or “Zone2” (see page 103).

■Adjusting the volume level of Zone 2 or Zone 3

Rotate VOLUME on the front panel (or press VOLUME +/– on the remote control) to adjust the volume level of the selected zone.

VOLUME

+

or VOLUME

–

y

Press MUTE on the remote control to mute the sound output to the selected zone.

Note

When you use the external amplifiers in Zone 2 or Zone 3, VOLUME +/– can be used only when “Zone2 Volume” or “Zone3 Volume” is set to “Variable” in “Zone2 Set” or “Zone3 Set” (see page 104).

■Adjusting the balance of the speaker level in Zone 2 or Zone 3

Press TONE CONTROL repeatedly to select “BALANCE” and then rotate PROGRAM on the front panel to adjust the balance of the front left and right speaker level of the selected zone.

TONE

CONTROL

PROGRAM

■Adjusting the tonal quality of Zone 2 or Zone 3

Set the operation mode selector to AMP and then press CH +/– on the remote control to adjust the high-frequency response (TREBLE) or

TV VOL +/– to adjust the low-frequency response (BASS) respectively.

+

TV VOL

–

AMP

BASS

SOURCE

TV

+

CH

–

TREBLE

y

You can also adjust the tonal quality of Zone 2 or Zone 3 by using TONE CONTROL on the front panel. For details, see “Adjusting the tonal quality” on page 52.

Note

Check that “ZONE 2” or “ZONE 3” is displayed in the display window of the remote control before you adjust the tonal quality of the corresponding zone (see page 123).

124 En