Yamaha RX-V2700 Connecting the power cable, 32 En, Connecting the AC power cable, Memory back-up

CONNECTIONS

Connecting the power cable

■Connecting the AC power cable

CAUTION

Use the supplied AC cable. Do not use other AC power cables as doing so may result in fire or electrical shock.

Plug the supplied AC power cable into the AC inlet after all other connections are complete, then plug the AC power cable into an AC wall outlet.

AC IN

To the AC wall outlet

AC OUTLETS

■VOLTAGE SELECTOR

(Asia and General models only)

CAUTION

The VOLTAGE SELECTOR on the rear panel of this unit must be set for your local voltage BEFORE plugging the power cable into the AC wall outlet. Improper setting of the VOLTAGE SELECTOR may cause damage to this unit and create a potential fire hazard.

Rotate the VOLTAGE SELECTOR clockwise or counterclockwise to the correct position using a straight slot screwdriver.

Voltages are as follows:

.............................. 110/120/220/230–240 V AC, 50/60 Hz

■AC OUTLET(S) (SWITCHED)

U.K. and Australia models	..................................... 1 outlet
Korea model	None
Other models	2 outlets

Use these outlet(s) to supply power to any connected components. Connect the power cable of your other components to these outlet(s). Power to these outlet(s) is supplied when this unit is turned on. However, power to these outlet(s) is cut off when this unit is turned off. For information on the maximum power or the total power consumption of the components that can be connected to these outlet(s), see “SPECIFICATIONS” on page 146.

Memory back-up

The memory back-up circuit prevents the stored data from being lost even if this unit is in the standby mode. However, the stored data will be lost in case the power cable is disconnected from the AC wall outlet or if the

VOLTAGE

SELECTOR

230-

240V

Voltage indication

power supply is cut off for more than one week.

32 En