Yamaha RX-V2700 Controlling Zone 2 or Zone, 122 En, Using the internal amplifiers of this unit

USING MULTI-ZONE CONFIGURATION

■Using the internal amplifiers of this unit

IMPORTANT SAFETY NOTICE

The SP1 or SP2 speaker terminals of this Receiver should not be connected to a Passive Loudspeaker Selector Box or more than one loudspeaker per channel.

Connection to a Passive Loudspeaker Selector Box or multiple speakers per channel could create an abnormally low impedance load resulting in amplifier damage. See this owner’s manual for correct usage.

Compliance with minimum speaker impedance information for all channels must be maintained at all times. This information is found on the back panel of your Receiver.

If you want to use one internal amplifier (SP1 or SP2) of this unit

Connect the Zone 2 or Zone 3 speakers directly to the SP1 or SP2 speaker terminals and select either “INT:[SP1]” or “INT:[SP2]” for “Zone2 Amplifier” or “Zone3 Amplifier” (see page 104).

If you want to use two internal amplifiers (both SP1 and SP2) of this unit

Connect the Zone 2 or Zone 3 speakers directly to the SP1 and SP2 speaker terminals and select “Both” for “Zone2 Amplifier” or “Zone3 Amplifier” (see page 104).

Second room

(Zone 2)

	+	SP1	+
R		–PRESENCE –		L	R SP2 L
					+
		SURROUND BACK/
R +		– BI-AMP –	+ L
			SINGLE		–

Third room

(Zone 3)

	This unit
Controlling Zone 2 or Zone 3
	2 Press ZONE CONTROLS on the front panel
You can select the zone you want to control by using the	repeatedly to select the zone you want to
	control.
control buttons on the front panel or on the remote control.
	ZONE CONTROLS

■Selecting Zone 2 or Zone 3

Front panel operations

1Press ZONE 2 ON/OFF or ZONE 3 ON/OFF on the front panel to individually turn on or off Zone 2 or Zone 3.

ZONE ON/OFF

ZONE 2 ZONE 3

y

Once MASTER ON/OFF on the front panel is pressed inward to the ON position, you can also press POWER and STANDBY on the remote control to turn on the main zone, Zone 2 and Zone 3.

Each time you press ZONE CONTROLS, the front panel display changes as shown below, and the indicator for the currently selected zone flashes for approximately 5 seconds. However, no indicator flashes when the main zone is selected.

ZONE2 ZONE3

No indicator flashes when the main zone is

selected.

ZONE2

Controls the Zone 2 amplifier or tuner functions.

ZONE3

Controls the Zone 3 amplifier or tuner functions.

122 En