Video Channel Set
Video Channel (RF Output Channel) is the channel on which your TV receives picture and sound signals from the video recorder through the RF cable.
q |
STOP/EJECT
TEST SIGNAL
The channel on which the screen to the left appear clearly in step 3 is your Video Channel.
To view picture signals from the video recorder, set your TV to the Video Channel.
Be sure to connect the power plug to an AC outlet first before installing the lithium battery; otherwise, the battery's service life will be drastically shortened.
EN
5
The video recorder is designed to send picture and sound signals via the connected RF cable to your TV on UHF channel 36.
After you have turned on the recorder, set your TV to UHF channel 36,
● If clear enough | you don't have to perform the following |
| steps. Go to "Installing/Removing the |
| lithium battery" on this page. |
● If not | UHF channel 36 or neighbouring channels |
| may be occupied by local stations. Perform |
| the following steps to change the Video |
| Channel to another channel between |
| 32 – 40. |
Before starting, make sure of the following:
●The recorder's power should be off.
●No cassette should be inserted in the recorder.
●The connected TV's power should be on.
1 |
| SET TV CHANNEL |
| Set your TV to a channel between 32 and 40 that you | |
| want to use as the Video Channel on the TV. | |
|
| BRING TEST SIGNAL ON |
2 |
| SCREEN |
| Hold down the recorder's STOP/EJECT button for more | |
| than 5 seconds. | |
|
| |
| ● "– OUT" appears on the display panel. | |
|
|
|
3 |
| TUNE YOUR RECORDER |
| Turn the RF output channel adjustment screw on the | |
| rear panel of the recorder by using a screwdriver until | |
| the two vertical bars become as clear as they can be. | |
|
| EXIT VIDEO CHANNEL SET |
4 |
| MODE |
| Press the recorder's STOP/EJECT button again to finish | |
| the setting. |
Installing/Removing the lithium battery
1Make sure that the power plug is connected to an AC outlet and turn off the VCR power.
2Open the battery cover while pressing the release tab as illustrated.
3Insert a lithium battery with the plus (+) side up and push it in.
●To remove the lithium battery, press the latch A down- ward using a pointed
4Close the battery cover until it clicks in place.
A |
