JVC HR-J748EE, HR-J749EE Unplug Vcrs Power, SET Remote Control, Code, Plug in Power Cord

EN15

VCR		1		2	3
		4		5	6	NUMBER
NUMBER	"1"	7		8	9
				0		"2"
		2
						PLAY
		1		3		Á
		¦		7		8
		1		4		¢
			STOP
		3

Repeat Playback

Your video recorder can automatically play back the whole tape 20 times repeatedly.

Control Two JVC VCRs

The remote control is capable of controlling two JVC VCRs independently; one set to respond to your remote control's A code control signals and another set to respond to B code control signals. The remote control is preset to send A code signals because your VCR is initially set to respond to A code signals. You can easily modify your VCR to respond to B code signals.

		UNPLUG VCR'S POWER
1		CORD
		Unplug from the AC outlet.
		SET REMOTE CONTROL
2		CODE
		While holding down VCR on the remote control, press
	the NUMBER key "2" and then press STOP.
3		PLUG IN POWER CORD
		Plug back in to the AC outlet.
4		TURN VCR POWER ON
		Press	on the remote.

The VCR will now respond only to B-code commands.

To set the VCR back to respond to A code signals, repeat the same procedure as shown above except pressing NUMBER key "1" instead of "2" in step 2.

You can control two VCRs with the same remote control by switching the remote's code between A and B.

1

2

3

START PLAYBACK

Press PLAY.

ACTIVATE REPEAT

PLAYBACK

Press PLAY and hold for over 5 seconds, then release.

●The Play indicator ($) on the display panel blinks slowly.

●The tape plays 20 times automatically, and then stops.

STOP PLAYBACK

Press STOP at any time to stop playback.

NOTE:

Pressing PLAY, REW, FF or PAUSE also stops Repeat Playback.