Controlling Multi Zone Components
■Operating on the AV receiver
Input selector buttons
MASTER VOLUME
ZONE 3
ZONE 2 | OFF |
Tip
•The Whole House Mode function shares the input source of main room with Multi Zone (➔ page 52).
1 To turn on Zone 2/3 and select an input source, press ZONE 2 or ZONE 3 followed by an input selector button within 8 seconds.
Zone 2/3 turns on, the Z2 or Z3 indicator lights on the AV receiver’s display.
Tip
• The corresponding trigger output goes high (+12 V).
To select AM or FM, press ZONE 2 or ZONE 3 and the TUNER input selector repeatedly.
To select the same source as the main room’s, press ZONE 2 or ZONE 3 twice. “Zone 2 Selector:
Source” or “Zone 3 Selector: Source” appears on the
AV receiver’s display.
2 To turn off Zone 2/3, press ZONE 2 or ZONE 3. The Z2/Z3 indicator on the AV receiver’s display flashes. Press OFF.
The zone is turned off.
Tip
•The corresponding trigger output goes low (0 volts).
■Operating on the remote controller
To control Zone 2/3, you must press ZONE on the remote controller first.
ZONE turns red when Zone 2 is on, and green when Zone 3 is on.
8RECEIVER
ZONE
Input selector buttons
MUTING
VOLq/w
1 Press ZONE repeatedly, then point the remote controller at the AV receiver and press 8RECEIVER.
Zone 2/3 turns on, the Z2 or Z3 indicator lights on the AV receiver’s display.
Tip
• The corresponding trigger output goes high (+12 V).
2 To select an input source for Zone 2/3, press ZONE repeatedly, followed by an INPUT SELECTOR button.
To select AM or FM, press ZONE and the TUNER input selector repeatedly.
Advanced Operations
3 To turn off Zone 2/3, press ZONE repeatedly, followed by 8RECEIVER.
The zone is turned off.
Tip
• The corresponding trigger output goes low (0 volts).
Adjusting the Volume for Zones
■Operating on the remote controller
1 | Press ZONE repeatedly. |
2 | Use VOL q/w. |
■Operating on the AV receiver
1 | Press ZONE 2 or ZONE 3 (the Z2/Z3 indicator on |
| the AV receiver’s display flashes). |
2 | Use MASTER VOLUME control within 8 seconds. |
If your Zone 2/3 speakers are connected to a receiver or integrated amplifier in Zone 2/3, use its volume control to adjust the volume.
