Onkyo TX-NR1010 En-58, `1ch, Audio signal is outputted from SW1 jack only, ` 2ch

ENTER.

Use q/wto select a sub menu item, and then press

ENTER.

Use q/wto select a setting target, and use e/rto change the setting.

Press HOME to close the menu.

Using the Setup Menu (HOME)

RECEIVER

ENTER q/w/e/r

RETURN HOME

1 Press RECEIVER followed by HOME.

2 Use e/rto select “Setup”, and then press ENTER.

3 Use q/wto select a main menu item, and then press

■Screen Saver

If there is no video signal on the current input source and no operation for a specific time (three minutes by default), a screen saver automatically comes on.

Tip

•The time until the screen saver activates itself can be changed in the “Screen Saver” setting (➔ page 79).

•The screen will return to its previous state if the AV receiver is operated.

Advanced Operations

Explanatory Notes

a Main Menu Speaker Setup

bSpeaker Configuration

c■ Subwoofer

d `1ch:

Audio signal is outputted from SW1 jack only.

`2ch:

Audio signal is outputted from SW1 and

SW2 jacks.

aMain Menu

bSub Menu

cSetting target

dSetting options (default setting underlined)

4

5

Sub Menu

Press RETURN to return to the previous menu. Main Menu

Note

•This procedure can also be performed on the AV receiver by using SETUP, the cursor and enter (middle) buttons.

•During Audyssey MultEQ® XT32 Room Correction and Speaker Setup, messages, etc., that are displayed on the TV screen will appear on the AV receiver’s display.

En-58