■Gateway
Enter the gateway address provided by your ISP.
■DNS Server
Enter the DNS server address provided by your ISP.
■Proxy URL
To use a Web proxy, enter its URL here.
■Proxy Port
If you’re using a Web proxy, enter a proxy port number here.
■Network Standby
`On
`Off
This setting enables or disables control over the network. When enabled, the NET indicator will be
Note
•When set to “On”, the power consumption slightly increases in standby mode.
■Update Notice
`Enable
`Disable
When this setting is enabled, you will be notified if a firmware update via network is available.
Note
•Selecting “Never Remind me” on the notification window will switch this setting to “Disable” (➔ page 23).
•For details on the update notification, see “If the “Firmware Update Available” window appears.” (➔ page 23).
Remote Controller Setup
1 
2 
3 
4 “Setup” 
5 
Main Menu | Remote Controller Setup |
Remote ID
■Remote ID
`1, 2, or 3
When several Onkyo components are used in the same room, their remote ID codes may overlap. To differentiate the AV receiver from other components, you can change its remote ID from “1”, to “2” or “3”.
Note
•If you do change the AV receiver’s remote ID, be sure to change the remote controller to the same ID (see below), otherwise, you won’t be able to control it with the remote controller.
Changing the remote controller’s ID
1 | While holding down RECEIVER, press and hold |
| down Q SETUP until the RECEIVER lights (about |
| 3 seconds). |
2 | Use the number buttons to enter ID 1, 2, or 3. |
| RECEIVER flashes twice. |
Remote Mode Setup
See “Looking up for Remote Control Codes”
(➔ page 90).
Advanced Operations
Lock Setup
1 
2 
3 
4 “Setup” 
5 
Main Menu | Lock Setup |
With this preference, you can protect your settings by locking the setup menus.
■Setup
`Locked
`Unlocked
When “Locked” is selected, the setup menus will be locked and you cannot change any setting.
Initial Setup
If you skipped the initial setup wizard, for example on
See “Initial Setup” (➔ page 24).
