Changing the Speaker Setup Manually
You can manually make changes to the settings found during Audyssey MultEQ® XT32 Room Correction and Speaker Setup.
See also:
•“Speaker Configuration” (➔ page 64)
•“Speaker Distance” (➔ page 65)
•“Level Calibration” (➔ page 66)
•“Equalizer Settings” (➔ page 66)
Note
•Please note that THX recommends any THX main speakers be set to “80Hz(THX)”. If you set up your speakers using Audyssey MultEQ XT32 Room Correction and Speaker Setup, please make sure manually that any THX speakers are set to “80Hz(THX)” crossover (➔ page 64).
•Sometimes due to the electrical complexities of subwoofers and the interaction with the room, THX recommends setting the level and the distance of the subwoofer manually.
•Sometimes due to interaction with the room, you may notice irregular results when setting the level and/or distance of the main speakers. If this happens, THX recommends setting them manually.
Using a Powered Subwoofer
If you’re using a powered subwoofer and it outputs very
If the “Subwoofer” appears on the “Review Speaker Configuration” screen as “No”, increase the subwoofer’s volume to the
Using the Listening Modes
Selecting Listening Modes
See “About Listening Modes” for detailed information about the listening modes (➔ page 43).
■Listening Mode Buttons
Press RECEIVER first.
MUSIC GAME
MOVIE/TV THX
PURE AUDIO MOVIE/TV, MUSIC, GAME, THX
En-42
Turning On & Basic Operations
MOVIE/TV button
This button selects the listening modes intended for use with movies and TV.
MUSIC button
This button selects the listening modes intended for use with music.
GAME button
This button selects the listening modes intended for use with video games.
THX button
This button selects the THX listening modes.
PURE AUDIO button and indicator
This button selects the Pure Audio listening mode.
When this mode is selected, the AV receiver’s display and analog video circuitry are turned off. Only video signals input through HDMI input can be output from the HDMI output. The indicator lights when this mode is selected. Pressing this button again will select the previous listening mode.
•The Dolby Digital and DTS listening modes can only be selected if your
•The listening modes you can select depends on the format of the input signal. To check the format, see “Displaying Source Information” (➔ page 51).
•While a pair of headphones is connected, you can select the following listening modes: Pure Audio, Mono, Direct, and Stereo.