Update Procedure
1 Press RECEIVER followed by HOME on the remote controller.
The Home menu appears on the TV screen.
2 Select “Firmware Update” and press ENTER. Note that the “Firmware Update” option will be grayed out for a short while after the AV receiver is turned on. Please wait until it becomes operable.
3 Select “Update via NET” and press ENTER.
Note that this option will not be available if there is no firmware file newer than the currently installed version.
4 Select “Update” and press ENTER. The update process will begin.
During the update process, the
5 The message “Completed!” appears on the AV receiver’s display, indicating that the update has been completed.
6 Turn off the AV receiver using 8ON/STANDBY on the front panel.
Do not use 8RECEIVER on the remote controller. Once turned off, the AV receiver will automatically turn on again.
Congratulations! You now have the latest firmware installed on your Onkyo AV receiver.
Troubleshooting
Case 1:
If an error occurs, “Error!!
■Errors during an update via network
Error Code | Description |
The Ethernet cable was not detected. | |
| Reconnect the cable properly. |
|
|
Internet connection error. | |
Check the following items: | |
| • Make sure the IP address, subnet mask, |
| gateway address, and DNS server are |
| configured properly. |
| • Make sure the router is turned on. |
| • Make sure the AV receiver and the router are |
| connected with an Ethernet cable. |
| • Make sure your router is configured properly. |
| See the instruction manual of the router. |
| • If your network allows only one client |
| connection and there is any other device |
| already connected, the AV receiver will not be |
| able to access the network. Consult your |
| Internet Service Provider (ISP). |
| • If your modem does not function as a router, |
| you will need a router. Depending on your |
| network, you may need to configure the proxy |
| server if necessary. See the document |
| provided by your ISP. If you are still unable to |
| access the Internet, the DNS or proxy server |
| may be temporarily down. Contact your ISP. |
|
|
Others | Retry the update procedure from the beginning. |
| If the error persists, please contact Onkyo |
| Support (➔ page 106) and provide the error |
| code. |
|
|
Case 2:
If an error occurs during the update process, disconnect then reconnect the AC power cord and try again.
En-104
Appendix
Case 3:
If you do not have an Internet connection to the network, please contact Onkyo Support (➔ page 106).