Turning On/Off the AV | Turning On | |
Receiver | 1 Press 8ON/STANDBY on the front panel. | |
8ON/STANDBY | or | |
Press RECEIVER followed by 8RECEIVER on the | ||
| ||
| remote controller. | |
| The AV receiver comes on and its display lights. | |
| Turning Off | |
| 1 Press 8ON/STANDBY on the front panel. | |
| or | |
| Press RECEIVER followed by 8RECEIVER on the | |
| remote controller. | |
| The AV receiver will enter standby mode. To prevent | |
| any loud surprises when you turn on the AV receiver, | |
| always turn down the volume before you turn it off. | |
| Tip | |
| • The HYBRID STANDBY indicator may light depending on the | |
| status of settings (➔ page 59). | |
| • For details on power management settings, see “Auto Standby” | |
| (➔ page 81). | |
8RECEIVER |
|
RECEIVER
Turning On & Basic Operations
■Smooth Operation in a Few Easy Steps (Initial Setup)
To ensure smooth operation, here’s a few easy steps to help you configure the AV receiver before you use it for the very first time. These settings only need to be made once. See “Initial Setup” for details (➔ page 24).
■If the “Firmware Update Available” window appears.
When a new version of the firmware is available, the notification window “Firmware Update Available” pops up. This notification only appears when the AV receiver is connected to your home network
(➔ page 114). To perform the firmware update, follow the instructions on screen.
Use q/wand ENTER on the AV receiver or remote controller to select one of the options.
`Update Now:
Starts the firmware update.
Refer to “Firmware Update” (➔ page 103).
`Remind me Later:
The update notification will pop up again the next time you turn the AV receiver on.
`Never Remind me:
Disables the automatic update notification.
Tip
•The update notification window can be enabled or disabled in “Update Notice” (➔ page 82).
