Onkyo TX-NR1010 instruction manual En-87, Using a Multiroom Kit with Other Components

From the connecting block

Miniplug cable

AV receiver

Advanced Operations

Using a Multiroom Kit with Other

Components

In this setup, an IR emitter is connected to the AV receiver’s IR OUT jack and placed in front of the other component’s remote control sensor. Infrared signals received at the AV receiver’s IR IN jack are fed through to the other component via the IR emitter. Signals picked up by the AV receiver’s remote control sensor are not output.

Signal flow

Connecting block

IR receiver

Using a Multiroom Kit with a Cabinet

In this setup, the IR receiver picks up the infrared signals from the remote controller and feeds them to the AV receiver located in the cabinet via the connecting block.

IR

Connecting receiver block

IR IN

Inside	Remote controller
cabinet
Signal flow

IR IN	AV receiver
IR OUT
	IR Emitter

Remote controller

Other component

Signal flow

The IR emitter should be connected to the AV receiver’s IR OUT jack, as shown below.

From the connecting block

Miniplug cable

Other component

Remote control sensor

AV receiver

Emitter

IR Emitter

Miniplug

Signal flow

En-87