Onkyo TX-NR1010 En-68, Audio Adjust, Multiplex/Mono, Overlap, High Level, Low Level

■Overlap

`No

`Yes

With this setting, a frequency band near the specified crossover frequency is output by both tweeters and woofers. Based on the frequency selected for “Crossover”, the cutoff frequency of the low-pass filter (LPF) will be set to 1/3 octave up and that of the high-pass filter (HPF) to 1/3 octave down. Example: With a “Crossover” of “3200Hz”, the cutoff frequency of the woofers’ LPF will be “4000Hz”, and the tweeters’ HPF will be “2500Hz”.

Tip

•Sounds processed by Digital Processing Crossover Network are played.

•You can switch from the current audio source to test noises by pressing MODE/D (Blue).

•In the case of usage of the bi-amped speakers, if there is a difference between the crossover frequency in the speakers’ built- in network and the crossover frequency to be set on the AV receiver, the frequency dip may be caused. Therefore, it is recommended that this function should be set to “Yes”.

■High Level, Low Level

`–6.0dBto 0.0dB to +6.0dB in 0.5 dB steps.

With this setting, you can set the volume of tweeters and woofers.

Tip

•Sounds processed by Digital Processing Crossover Network are played.

•You can switch from the current audio source to test noises by pressing MODE/D (Blue).

■High Phase, Low Phase

`0º

`180º:

With this setting, you can adjust the phase of tweeters and woofers.

Tip

•Sounds processed by Digital Processing Crossover Network are played.

•You can switch from the current audio source to test noises by pressing MODE/D (Blue).

■High Distance, Low Distance

`0inch(0.0cm) to 12inch(30.0cm) in 1 inch (2.5 cm) steps.

With this setting, you can adjust the virtual position of tweeter and woofer units. Adjusting “High Distance” virtually shifts woofers behind tweeters. Adjusting “Low Distance” virtually shifts tweeters behind woofers.

Tweeter
Distance	Distance
Woofer
(Low Distance)	(High Distance)

Tip

•Sounds processed by Digital Processing Crossover Network are played.

•You can switch from the current audio source to test noises by pressing MODE/D (Blue).

Advanced Operations

Audio Adjust

1 2 3 4 “Setup” 5

Main Menu Audio Adjust

With the Audio Adjust functions and settings, you can adjust the sound and listening modes as you like.

Multiplex/Mono

■Multiplex

Input Channel

`Main

`Sub

`Main/Sub

This setting determines which channel of a stereo multiplex source is output. Use it to select audio channels or languages with multiplex sources, multilingual TV broadcasts, and so on.

■Mono

Input Channel

`Left + Right

`Left

`Right

This setting specifies the channel to be used for playing any 2-channel digital source such as Dolby Digital, or 2- channel analog/PCM source in the Mono listening mode.

En-68