JVC HR-S3800U manual Video Calibration, Picture Control, Auto Timer, Superimpose

		EN 39
		* The default setting is bold in the table below.
m VIDEO CALIBRATION		When this function is set to “ON”, this VCR checks the condition of the
ON		tape in use during playback and recording, and compensates to provide
		the highest-possible pictures. This takes place whenever you play back a
OFF
		tape or start recording after inserting a tape.
		NOTES:
		c During playback, this function is always working even though “VIDEO
		CALIBRATION” appears just at the beginning of automatic tracking.
		c During recording, this function works only for the first EP recording and the first
		SP recording on an inserted tape.
		For timer recording, this function checks the tape condition both for the SP
		recording and the EP recording before the first timer recording starts.
		c When you play back rental tapes or tapes recorded on other VCRs, set this
		function either “ON” or “OFF” whichever gives you the best picture.
m PICTURE CONTROL		This function helps you to adjust the playback picture quality according
		to your preference.
AUTO (NORM): Normally select
	this. Picture quality is	NOTES:
	adjusted automatically.
	When “VIDEO	c When you select “EDIT”, “SOFT” or “SHARP”, the selected mode will not
	CALIBRATION” is “OFF”,	change until you select again.
		c Select "EDIT" when you are editing tapes (Z pg. 45, 46, and 49). After you
	“NORM” will appear instead
		finish editing the tapes, select “AUTO” (“NORM” when “VIDEO
	of “AUTO”.
		CALIBRATION” is “OFF”.)
EDIT:	Minimizes picture
	degradation during editing
	(recording and playback).
SOFT:	Reduces image
	coarseness when viewing
	overplayed tapes
	containing much noise.
SHARP: Clearer, sharper-edged
	picture when viewing
	images with much flat,
	same-colored surfaces
	such as cartoons.
m AUTO TIMER		c When this function is set to ÒONÓ:
ON		The timer recording standby mode is automatically engaged when the
OFF		VCR is turned off. It is temporarily canceled when the VCR is turned
		on. You do not have to press TIMER to engage or disengage the timer
		recording standby mode.
		c When this function is set to ÒOFFÓ:
		You have to press TIMER to engage or disengage the timer recording
		standby mode.
m SUPERIMPOSE		When this function is set to “ON”, various VCR status information (on-
ON		screen display) appears on the screen.
OFF		NOTES:
		c When you use this VCR as the playback VCR for editing a tape, be sure to set
		this function to “OFF”; otherwise, the VCR status information (on-screen
		display) will be recorded on the edited tape.
		c If you select a channel on which no signal is received, the channel number is
		displayed regardless of this function setting.

HR-S4800U/S3800U-EN38-43 39 00.1.31, 10:01 AM