Paradyne 3800PLUS Flow Control of DTE, Flow Control of Modem, Q2, No Data Disconnect Timer, T0

AT Command Set and S-Registers

Table 13-1

(11 of 11)

3800Plus AT Commands

AT Command			Description		Front Panel Branch
\Qn	Flow Control of DTE, Flow Control of Modem				Configure\Edit\
					V42/MNP/Buffer
			Flow	Flow
			Control	Control of
			of DTE	Modem
		\Q0	Disable	Disable
		\Q1	XON/XOFF	XON/XOFF
		\Q2	CTS to DTE	Disable
		\Q3	CTS to DTE	RTS to Mdm
		\Q4	XON/XOFF	Disable
		\Q5	Disable	XON/XOFF
		\Q6	Disable	RTS to Mdm
\Tn	No Data Disconnect Timer				Configure\Edit\
	\T0	Disable.			Line Dialer
	\Tn Where n is a value from 1 to 255 in 1-minute increments.
\Xn	XON/XOFF Passthrough Flow Control				Configure\Edit\
	\X0	Disable.			V42/MNP/Buffer
	\X1	Enable.
%An	Error Control Fallback Character				Configure\Edit\
	%An Where n is an ASCII value from 0 to 127. Factory default is				V42/MNP/Buffer
		013 ASCII.
%Cn	MNP5 Data Compression				Configure\Edit\
	%C0	Disable.			V42/MNP/Buffer
	%C1	Enable.
IHn	V.42bis Compression				Configure\Edit\
	IH0	Disable.			V42/MNP/Buffer
	IH1 Transmit only. (Not available from DCP.)
	IH2 Receive only. (Not available from DCP.)
	IH3 Transmit and Receive. (Equivalent to Enabled option on DCP.)
+FCLASS=n	Service Class Selection
	Normally set by fax software, Service Class Selection determines the fax
	protocol. The command is sent to the modem in the format +FCLASS=n,
	where n can be set to one of three values:
	0=Data
	1=Class 1 Fax (EIA 578)
	2=Class 2 Fax (EIA/TIA SP-2388 dated 20 August 1990)
	In the format +FCLASS?, the +FCLASS command returns the current
	Service Class: 0, 1, or 2. In the format +FCLASS=?, the +FCLASS
	command returns the Service Classes available: 0, 1, 2.
	NOTE: Other fax commands supported by the 3800Plus modems are not
		documented in this manual because they are not normally issued
		by the user. They follow the EIA 578 and EIA/TIA SP-2388
		specifications.

3980-A2-GB30-20 November 1996 13-13