Paradyne 3800PLUS manual 3 of 3800Plus S-Registers, AT Command, Description, Front Panel Branch

COMSPHERE 3800Plus Modems

Table 13-2

(3 of 13)

3800Plus S-Registers

AT Command

Description

Front Panel Branch

S14

S18

Asymmetric Rate Mode	Configure\Edit\
Register determines whether VF rates for transmitting and receiving are	Dial Line
identical when using V.34 modulation. Enabling the function permits the
two rates to be different.
Register has the following values:
0=Enable
1=Disable
Factory setting is Enable.
Test Timeout	Configure\Edit\
Register sets the duration (in seconds) for the modem tests. This	Tests
automatically cancels any test in progress after the time of this register
expires. Any test can be manually canceled by issuing the escape
sequence (+++) followed by the &T0 command.
Enter a value from 0±255 seconds. (A value of 0 disables this register.)
Factory setting is Disable (0).

S26	RTS-to-CTS Delay	Configure\Edit\
	Register sets the length of time (in 10-millisecond increments) the modem	DTE Interface
	waits after receiving RTS before issuing CTS to the DTE.
	Enter a value from 0±255.
	Factory setting is 0 milliseconds.
S36	Rate Auto Originate	Configure\Edit\
	Initiates a dial backup call, using the phone number or numbers	Leased Line
	determined by S-register S37 when the leased-line rate of the modem falls
	back to or below a certain speed.
	Register has the following values:
	0=Disable
	1=On fallback to 4,800
	2=On fallback to 7,200
	3=On fallback to 9,600
	4=On fallback to 12,000
	5=On fallback to 14,400
	6=On fallback to 16,800
	NOTE: Rate Auto-Originate is valid only when V.32bis Autorate is
	enabled (S76=0) and when running V.32bis modulation.

13-16 November 1996 3980-A2-GB30-20