Paradyne 3800PLUS manual of Leased Line Configuration Options

Configure Branch

Leased Line

The Leased Line configuration options are used to configure the modem for operation over leased lines.

NOTE

The Leased Line configuration group only appears if the modem is configured with the Sync Leased factory preset template.

The Leased Line configuration group only appears if the modem is configured with the Sync Leased factory preset template.

Table 8-5 shows each Leased Line configuration option as it appears on the LCD, with the Async Dial factory default setting (the default value if the modem is just being installed) shown following the colon (:) on the first line and with all available selections listed on the second line. Following this is a description of the configuration option, a description of the available selections, and any equivalent AT commands.

Table 8-5

(1 of 4)

Leased Line Configuration Options

*Leased Mode: 4WLL-Orig

Nxt 4WLL-Orig 4WLL-Ans 2WLL-Orig 2WLL-Ans

Leased Mode. Sets the modem for either 2-wire or 4-wire operation in Answer mode (receiving a call) or 2-wire or 4-wire operation in Originate (initiating a call) mode.

NOTE: For proper operation over leased lines, one modem must be set for Originate mode, and the other modem must be set for Answer mode.

For Sync Leased Answer Mode, 4-wire, Answer is the factory default.

For Sync Leased Originate Mode, 4-wire, Originate is the factory default.

AT command equivalent is &Ln.

*Modulation: V34

Nxt V34 V32bis/terbo V22bis V29/V33

Modulation determines the modem's primary leased line modulation group: V.34; V.32bis and V.32terbo; V.22bis; or V.29 and V.33 (if installed).

The factory default is V34 (V.34 modulations).

* This configuration option is only available if the Sync Leased factory preset template is selected.

3980-A2-GB30-20 November 1996 8-27