Paradyne 3800PLUS manual Identity, AT Command Equivalent

Status Branch

Identity

Identity displays the modem's serial number, model number, firmware revision level, hardware part number and firmware part number. Retrieval of this information is useful if you are purchasing additional or replacement modems and/or making firmware upgrades.

To access Identity from the Status branch, make the following selection:

Status:
VF		Identity
F1	F2	F3

Select Identity.

Status : Identity >

Ser # = 00000000

F1 F2 F3

The modem's serial number is displayed on the LCD's

bottom line. Press the key to scroll and view the model number, firmware revision level, hardware part number, and firmware part number.

Ser # Serial number is an 8-digit number that identifies the modem.

Mod # Model number is an alphanumeric number that identifies the modem as either a 3810Plus modem (if the model number begins with 3980), a 3811Plus modem (if the model number begins with 3981), or a 3820Plus modem (if the model number begins with 3982).

FRev Firmware revision level is an alphanumeric number that identifies the level of firmware loaded in the modem.

HPt # Hardware part number is an 11-digit number that identifies the circuit card in the modem.

FPt # Firmware part number is an 11-digit number that identifies to service personnel the firmware release number.

To exit this function and remain in the Status branch,

press the key. To exit and return to the Top-Level

menu, press the key.

AT Command Equivalent

The AT command I0 displays the product code, normally 144.

The AT command I1 displays an abbreviated firmware revision number.

The AT command I2 performs an EPROM check and displays OK or Error.

The AT command I3 displays the modem's serial number.

The AT command I4 displays the modem's model number.

The AT command I5 displays the part number of the circuit card.

The AT command I6 displays the firmware release number.

The AT command I9 displays the firmware revision number (same as I1).

The AT command I10 alters the value of the product code displayed with the I0 command. See Chapter 13 for more information about the I0 command.

The AT command I11 performs a checksum of the modem's firmware and displays the results in hexadecimal. (There is no DCP equivalent of this command.)

The AT command I19 displays the firmware revision level.

3980-A2-GB30-20 November 1996 6-3