Paradyne 3800PLUS RemClone Status Establish Remote, RemClone Status Initializing, No Response

Control Branch

WARNING

Pressing any function key now begins the transfer to the remote modem. This process takes the communications link out of service for several minutes depending upon the data rate of the link (28,800 bps = 5 minutes; 14,400 bps = 10 minutes; 9600 bps = 15 minutes;

4800 bps = 30 minutes). If the Clone to Remote process is started and then interrupted, the remote modem is left in a partially programmed state in which its functional capabilities are limited to those required to initiate and complete another download attempt. If you cannot complete a download, call your service representative.

Press any function key (F1, F2, or F3) to begin the transfer.

RemClone Status

Establish Remote

F1 F2 F3

The local modem's LCD displays Establish Remote, indicating the modem is attempting to establish a Remote Cloning Download session with the remote modem.

If unsuccessful, the modem remains in the Download Transfer mode. The LCD's top line displays RemClone Failed and the bottom line displays one of the following messages:

Incompat Modulat	The modems are connected,
	but are using a modulation
	scheme other than V.34, V.33,
	V.32bis, V.32, or V.29.
No Response	The remote modem is not a
	3800Plus modem or the
	connection between the two
	modems is poor.
Access Disabled	The remote modem's Access
	from Remote configuration is
	disabled.
Password Invalid	The local and remote
	modems' passwords do not
	match.

Correct the problem and attempt another download from the local modem. If this fails, contact your service representative.

After successful establishment of a Remote Cloning Download session, the following screens are displayed.

RemClone Status

Initializing

F1 F2 F3

RemClone Status

Bank 1 : xxxx/yyyy

F1 F2 F3

3980-A2-GB30-20 November 1996 9-5