Paradyne 3800PLUS manual 8 of 3800Plus S-Registers, AT Command, Description, Front Panel Branch

AT Command Set and S-Registers

Table 13-2

(8 of 13)

3800Plus S-Registers

AT Command

Description

Front Panel Branch

S53

V.54 Address

Identifies the address of the modem to be placed in a loopback test.

Register has the following values:

0 =Disable

1±34 =Modem address

Factory setting is Disable.

Configure\Edit\Tests

S54	V.54 Device Type	Configure\Edit\Tests
	Identifies where the modem is physically located in the network.
	Register has the following values:
	0=Peripheral
	1=Intermediate
	Factory setting is Peripheral.
S55	Access from Remote	Configure\Edit\Misc
	Register determines if a modem's DCP can be accessed by a remote
	modem.
	Register has the following values:
	0=Enable
	1=Disable
	The factory default templates do not affect S55.
S56	Remote Access Password (Part 1)	Configure\Edit\Misc
	Register allows entry of the first pair (leftmost) of digits of a remote access
	password. Any value from 00 to 99 is valid. For example, if the remote
	access password is 12345678, then S56=12.
S57	Remote Access Password (Part 2)	Configure\Edit\Misc
	Register allows entry of the second pair of digits of a remote access
	password. Any value from 00 to 99 is valid.
S58	Remote Access Password (Part 3)	Configure\Edit\Misc
	Register allows entry of the third pair of digits of a remote access
	password. Any value from 00 to 99 is valid.
S59	Remote Access Password (Part 4)	Configure\Edit\Misc
	Register allows entry of the fourth pair (rightmost) of digits of a remote
	access password. Any value from 00 to 99 is valid.
S61	CT111 Rate Control	Configure\Edit\
	Register determines if CT111 Rate is disabled, set for Fallback 1 or	DTE Interface
	Fallback 2. CT111 Rate allows the DTE to control modem rate via Pin 23
	of the EIA-232-D interface. This configuration option determines the effect
	of the DTE Rate Control signal. It is only valid in Async Direct mode and
	Synchronous mode. For proper operation, disable the V32bis Autorate and
	V32bis Automode configuration options.
	Register has the following values:
	0=Disable
	1=Fallback 1
	2=Fallback 2
	Factory setting is Disable.

3980-A2-GB30-20 November 1996 13-21