Paradyne 3800PLUS manual 12 of 3800Plus S-Registers, AT Command, Description, Front Panel Branch

AT Command Set and S-Registers

Table 13-2

(12 of 13)

3800Plus S-Registers

AT Command

Description

Front Panel Branch

S88

Straps When Disconnected

Register determines whether the Active(Operating) area is reloaded upon a disconnect.

Register has the following values:

0 (or 231)=No Change

1 (or 232)=Reload

2 (or 233)=Reload with no AT Change

The factory default templates do not affect S88.

Configure\Edit\Misc

S89	V.42 ARQ Window Size Increase		None
	Register allows the V.42 Automatic Request for Transmission (ARQ)
	window size to be set to a value from 6 to 15 frames to accommodate
	satellite delays.
	Register has the following values:
	0=6 frames (default)
	1=7 frames
	2=8 frames
	3=9 frames
	S	S
	S	S
	9=15 frames
	This command applies only to connections made using V.42bis data
	compression or V.42 error control.
	Factory setting is 6 frames.
S90	DTE Rate=VF Rate		Configure\Edit\
	Register forces the DTE (computer) data rate to be equal to the VF		DTE Interface
	(telephone line) data rate.
	Register has the following values:
	0=Disable
	1=Enable
	Factory setting is Disable.
S91	Cellular Enhancements		Configure\Edit\
	Register determines whether parameters are set to improve performance		V42/MNP/Buffer
	over a cellular link. Should be enabled when the remote modem is using a
	cellular connection.
	Register has the following values:
	0=Disable
	1=Enable
	Factory setting is Disable.

3980-A2-GB30-20 November 1996 13-25