Paradyne 3800PLUS 2 of 3800Plus AT Commands, Description, Front Panel Branch, Dial Stored Number

COMSPHERE 3800Plus Modems

Table 13-1

(2 of 11)

3800Plus AT Commands

AT Command		Description	Front Panel Branch
Dn (Cont'd)	, ±	Pause. Causes the modem to pause before processing the next
		character in the dial string. The length of this pause is determined by
		the setting of the Pause Time configuration option (see Line Dialer
		configuration option group) or by value held in S-register S8.
	; ± Return to Command mode. Modem returns to Command mode after
		dialing a number without disconnecting the call. This is useful when
		the number exceeds 40 characters, or when the wait time between
		parts of a dial string is unknown. This modifier disables the any-key
		abort function.
	Space, ± , and ( ) . These characters are ignored by the dial string and can
		be included in the dial string to enhance readability.
DS=n	Dial Stored Number		Call Setup\Dial\
	Dials the number stored in Location n (1±10). (To store a telephone		Dial Directory:
	number, refer to the &Zn=x command.)
	If any character is received from the DTE before the modem goes online,
	the dial sequence is aborted. This is known as any-key abort.
En	Command Character Echo		Configure\Edit\
	E0	Disables echo to the DTE.	DTE Dialer
	E1	Enables echo to the DTE.
Hn	Hook Switch Control		H0: Call
	H0	Modem goes on-hook.	Setup\Disconnect
	H1	Modem goes off-hook.	or
			Control\Remove Make
			Busy
			H1: Control\ Make Busy
In	Identification		Status\Identity
	I0	Displays product code; default is 144.
	I1	Displays 3-digit firmware revision number.
	I2	Performs an EPROM check.
	I3	Displays the modem's serial number.
	I4	Displays the modem's model number. The model number of a
		3810Plus begins with 3980. The model number of a 3811Plus
		begins with 3981. The model number of a 3820Plus begins with
		3982.
	I5	Displays the part number of the circuit card.
	I6	Displays the firmware release number.
	I9	Displays 3-digit firmware revision number (same as I1).
	I10=n Changes the value of the product code displayed by the
		I0 command; n is a number from 0 to 4:
		I10=0 sets product code to 144
		I10=1 sets product code to 240
		I10=2 sets product code to 480
		I10=3 sets product code to 960
		I10=4 sets product code to 120
	I11	Performs a checksum of the modem's firmware and displays the
		results in hexadecimal. (There is no DCP equivalent of this
		command.)
	I19	Displays the entire firmware revision level.

13-4 November 1996 3980-A2-GB30-20