Paradyne 3800PLUS manual 10 of 3800Plus S-Registers, AT Command, Description, Front Panel Branch

AT Command Set and S-Registers

Table 13-2

(10 of 13)

3800Plus S-Registers

AT Command	Description	Front Panel Branch
S74	Network Position Identification	Configure\Edit\Misc
	Register identifies each modem as either a control or tributary modem.
	Register has the following values:
	0=Tributary
	1=Control
	Factory setting is Tributary for the 3810Plus and the 3820Plus.
	Factory setting is Control for the 3811Plus.
S75	Network Management Address	Configure\Edit\Dial
	Register determines the modem's network address. This address is used
	when accessing the modem from the NMS.
	Enter a value from 0 (network address 001) to 255 (network address 256).
	The factory default templates do not affect S75.
S76	Autorate (Dial Line)	Configure\Edit\
	Register determines if Autorating is used on dial lines when connected in	Dial Line
	V.32bis or V.34 mode.
	Register has the following values:
	0=Enable
	1=Disable
	2=Start at 4800 bps
	3=Start at 9600 bps
	Factory setting is Enable.
S77	DTR Alarm Reporting	Configure\Edit\Misc
	Register determines whether an alarm is sent to the NMS controller when
	the DTR signal has been off for more than 10 seconds.
	Register has the following values:
	0=Disable
	1=Enable
	The factory default templates do not affect S77.
S78	Automode (Dial Line)	Configure\Edit\
	Register allows the modem (when operating on dial lines) to automatically	Dial Line
	detect and connect to the remote modem's modulation scheme.
	If the modem is in a modem pool attached to a System 85 Private Branch
	Exchange (PBX), S78 should be set to 2. This modifies parameters used
	during connection to the PBX.
	Register has the following values:
	0=Enable
	1=Disable
	2=System 85
	Factory setting is Enable.

3980-A2-GB30-20 November 1996 13-23