Paradyne 3800PLUS 7 of 3800Plus AT Commands, Description, Front Panel Branch, Dial Transmit Level

AT Command Set and S-Registers

Table 13-1

(7 of 11)

3800Plus AT Commands

AT Command		Description	Front Panel Branch
&I	Dial Transmit Level		Configure\Edit\Dial Line
	When Dial Transmit Level Type is set to Permissive, &In sets Dial Transmit
	Level to a value between ±10 and ±32 dBm. &I99 and &I100 cause the
	level to be varied automatically according to conditions for Enhanced
	Throughput Cellular (ETC) operation.
	&I10	±10 dBm
	&I11	±11 dBm
	S	S
	S	S
	&I32	±32 dBm
	&I99 Automatically adjusted according to the ETC1.0 specification. Use
		only with remote modems set to &I99, and limit the data rate to
		4800 bps (S41=5). Set by &F6.
	&I100 Automatically adjusted according to the ETC1.1 specification.
	NOTE: &J0 overrides this command; &In overrides the &J0 command.
&Jn	Dial Transmit Level Type		Configure\Edit\Dial Line
	&J0 Permissive (Approx. ±9 dBm).
	NOTE: &J0 overrides the &In command; &In overrides the
		&J0 command.
&Ln	Leased Mode		Configure\Edit\Leased
	&L0	Disables leased-line operation.	Line
	&L1	2-wire originate leased-line operation.
	&L2	4-wire originate leased-line operation.
	&L3	2-wire answer leased-line operation.
	&L4	4-wire answer leased-line operation.
	The &L command will cause the modem to reset before entering or exiting
	Leased-Line mode. Therefore, it must be entered as the last command in
	an initialization string. The modem must be in Sync Leased mode (&F2 or
	&F4) for the &L command to work.

3980-A2-GB30-20 November 1996 13-9