Paradyne 3800PLUS manual Call Setup Branch, Dial, AT Command Equivalent, Disconnect

COMSPHERE 3800Plus Modems

Call Setup Branch

In the following descriptions, the shaded key indicates what key to press to perform the described operation.

To access the Call Setup branch from the Top-Level menu, select Call Setup:

Idle: 28.8		>
Call_Setup
F1	F2	F3

Dial

Dial allows you to dial any telephone number stored in directory locations 1±10. Any telephone number dialed using the DCP must already exist in a directory location. Refer to Change Directory for information on storing telephone numbers in directory locations.

To access Dial from the Call Setup branch, make the following selection:

Call Setup:		>
Dial	Disconnect
F1	F2	F3

Select Dial to display the first directory telephone number.

Dial Directory:

Nxt 01:5551234

F1 F2 F3

To view other directory locations, select Nxt.

Dial Directory: 01

Dialing

F1 F2 F3

Once the directory location you want appears on the LCD, press the F2 or F3 key to dial the number.

If the connection is successful, the modem is online

and one of the Normal Operation status messages appears on the LCD. If the connection is not successful, the LCD displays one of the Call Failure status messages. (See Table 3-3 in Chapter 3.)

If DTE dialing is enabled and any character is received from the DTE before the modem goes online, the dial sequence is aborted. This is known as any-key abort.

AT Command Equivalent

The AT command equivalent for Dial is DS=n, where n is directory location 1±10.

Disconnect

Disconnect allows the modem to go on-hook (hang up). Use this function when you want to disconnect an established call on a dial line.

To access Disconnect from the Call Setup branch, make the following selection:

Call Setup:		>
Dial	Disconnect
F1	F2	F3

Select Disconnect.

5-2 November 1996 3980-A2-GB30-20