Paradyne 3800PLUS manual Remote Mode Fail ± No, Secondary channel only appears if using

COMSPHERE 3800Plus Modems

Remote DCP access is accomplished using either the primary or secondary channel (if available) of the VF line. Using the primary channel gives a much faster response time due to the higher data rate, but it also interrupts data flow because primary data is stopped when Remote mode is active. Once Remote mode is terminated, the primary channel is automatically made available to data transmission.

Unlike primary channel communications, the secondary channel operates at a slower data rate and does not interrupt data flow. (V.34, V.32terbo, V.32bis, and V.32 are the only modulations available on the secondary channel.)

To access the Remote branch, make the following selections:

Online : 28.8 <

Control Remote

F1 F2 F3

Press the key until Remote appears. Select Remote.

NOTE

If a connection is not established between a local 3800Plus modem and a remote 3800Plus modem, the LCD displays

Remote Mode Fail ± No

Circuit. Press the key to return to the Top Level menu, and dial again.

Select Channel		>
Secondary
F1	F2	F3

or

Select Channel		<
Prim (data blckd)
F1	F2	F3

If operation over the secondary channel is desired, press any function key to select the secondary channel.

Secondary channel only appears if using V.34,

V.32 terbo, V.32bis, or V.32 modulation. If operation

over the primary channel is desired, press the key until Prim appears, and press any function key.

Online : 28.8

Control ExitRem

F1 F2 F3

If the remote modem accepts the password and the entry is successful, the Top-Level menu of the remote modem appears on the local modem's LCD. An appears in the upper right-hand corner indicating that what is displayed on your LCD is actually the Top-Level menu of the remote 3800Plus modem.

10-2 November 1996 3980-A2-GB30-20