Paradyne 3800PLUS manual 7 of 3800Plus S-Registers, AT Command, Description, Front Panel Branch

COMSPHERE 3800Plus Modems

Table 13-2

(7 of 13)

3800Plus S-Registers

AT Command

Description

Front Panel Branch

S47

Auto Dial Standby

Register determines if the modem performs an automatic dial standby if in Dial Backup mode.

Register has the following values:

0=Disable 1=15 minutes 2=1 hour 3=4 hours

255=Test(2min)

Factory setting is Disable.

Configure\Edit\ Leased Line

S48	Leased-Line Carrier On Level		Configure\Edit\
	Register determines if the modem disconnects if the carrier signal on		Leased Line
	leased lines falls below ±26 dBm or ±43 dBm.
	Register has the following values:
	0= ±43 dBm
	1= ±26 dBm
	Factory setting is ±43 dBm.
S49	Transmit Buffer Disconnect Delay		Configure\Edit\
	Determines the maximum amount of time the modem can continue to send		V42/MNP/Buffer
	data in its Transmit Buffer to the remote modem after it is commanded by
	the DTE to disconnect.
	Register has the following values:
	0=Disable (Immediate disconnect)
	1=1 second
	2=2 seconds
	S	S
	S	S
	255=255 seconds
	Factory setting is 10 seconds.
S51	DTE RL (CT140)		Configure\Edit\Tests
	Register determines if the modem performs a remote digital loopback if it
	receives a CT140 signal from the DTE.
	Register has the following values:
	0=Disable
	1=Enable
	Factory setting is Disable.
S52	DTE LL (CT141)		Configure\Edit\Tests
	Register determines if the modem performs a local analog loopback if it
	receives a CT141 signal from the DTE.
	Register has the following values:
	0=Disable
	1=Enable
	Factory setting is Disable.

13-20 November 1996 3980-A2-GB30-20