Paradyne 3800PLUS of Security Configuration Options, DTEPWBkSpChar 008 Nxt, NMSReporting Nxt

Configure Branch

Table 8-9

(2 of 2)

Security Configuration Options

*DTE_PW_BkSpChar: 008 Nxt " 008

DTE Password Backspace Character. Sets the character that is used to perform a backspace in security mode. This character can be set to any ASCII value from 0 to 127.

The factory default is 08 (ASCII backspace).

Get_User_ID: Disable

Nxt Disable Enable

Get User ID. Determines whether the remote user is prompted for an NMS-defined logon ID once the modems have completed initial handshaking. For consistent operation from the remote user's viewpoint, all modems in a modem group must use the same setting.

Disable ± The user is prompted only for a password (if required by the setting of Answer Security Mode or the configuration of the VF-side password).

Enable ± The user is prompted for a login ID and then a password (if required by the setting of Answer Security Mode or the configuration of the VF-side password). NMS sends a disconnect command to the local modem if the login ID is invalid.

The factory default is Disable.

NMS_Reporting: 00

Nxt " 00

NMS Reporting. Determines whether and how dial access security events are reported to the NMS controller. The possible values, 00±15, represent a bit map. The bits are normally set using the NMS controller.

The value of NMS_Reporting is not affected by loading a factory default template. The initial value when the modem is shipped is 00.

Answer_Secur: No_Answ_Sec

Nxt No_Answ_Sec DTE_Only VF_&_DTE VF_w/_DTE

Answer Access Security Mode. This configuration option is read-only and cannot be changed from the Configure branch. The setting of this configuration option can only be changed in the Set Answer Sec group found in the Security branch.

The settings of this configuration option determine the type of access security protection provided by the modem. It can be disabled using the No_Answ_Sec setting, or it can be enabled with the DTE_Only, VF_&_DTE, or VF_w/_DTE settings.

Originate_Secur: No_OrigSec

Nxt No_OrigSec Ena_Orig_Sec

Originate Security Mode. This configuration option is read-only and cannot be changed from the Configure branch. The setting of this configuration option can only be changed in the Set Orig Sec group found in the Security branch.

This configuration option enables or disables security protection used for outbound calls when using the AT command autodialer function.

*This configuration option does not appear if the Answer Security Mode configuration option is configured for No Answer Security.

3980-A2-GB30-20 November 1996 8-43