Paradyne 3800PLUS manual 11 of 3800Plus S-Registers, AT Command, Description, Front Panel Branch

COMSPHERE 3800Plus Modems

Table 13-2

(11 of 13)

3800Plus S-Registers

AT Command

Description

Front Panel Branch

S80

S82

No Data Disconnect Trigger Signal	Configure\Edit\
Register determines whether Pin 2 (transmit data) or Pin 3 (receive data)	Line Dialer
of the modem's RS-232 serial interface is monitored so that the modem
can disconnect the call if there is no activity for a certain period. (See the
\T command.)
Register has the following values:
0=Transmit or Receive
1=Transmit only
2=Receive only
3=Transmit and Receive
Factory setting is 3.
Autorate (Leased Line)	Configure\Edit
Register determines if Autorating is used on leased lines when connected	Leased Line
in V.32bis or V.34 mode.
Register has the following values:
0=Enable
1=Disable
Factory setting is Enable.

S83	MI/MIC Dialing	Configure\Edit\
	On Model 3811Plus only, register determines if MI/MIC control leads can	Line Dialer
	be used to force the modem into the originate handshake after first dialing
	a call.
	Register has the following values:
	0=Disable
	1=Enable
	Factory setting is Disable.
S84	AT Command Mode	Configure\Edit\
	Register determines how the modem responds to valid and invalid	DTE Dialer
	AT commands.
	Register has the following values:
	0=Normal
	1=No ERROR
	2=No Strap or ERROR
	Factory setting is Normal.
S85	Fast Disconnect	Configure\Edit\
	Register allows the modem to disconnect immediately after receiving a	Line Dialer
	disconnect command from a local DTE or its own diagnostic control panel.
	Register has the following values:
	0=Disable
	1=Enable
	Factory setting is Disable.

13-24 November 1996 3980-A2-GB30-20