Paradyne 3800PLUS Line Feed Character, Backspace Character, Blind Dial Pause, No Answer Timeout

AT Command Set and S-Registers

Table 13-2

(2 of 13)

3800Plus S-Registers

AT Command

Description

Front Panel Branch

S4	Line Feed Character	Configure\Edit\
	Register determines ASCII value used as the line feed character.	DTE Dialer
	Enter a value from 0±127 for the line feed character.
	Factory setting is 10 (ASCII carriage return or line feed).
S5	Backspace Character	Configure\Edit\
	Register determines ASCII value used as the backspace (Backspace key).	DTE Dialer
	This character moves the cursor to the left and erases the previous
	character.
	Enter a value from 0±127.
	Factory setting is 08 (backspace key).
S6	Blind Dial Pause	Configure\Edit\
	Register determines how long (in seconds) the modem waits after going	Line Dialer
	off-hook before dialing a telephone number if using result code X0, X1, or
	X3.
	Enter a value from 2±255 seconds.
	Factory setting is 2 seconds.
S7	No Answer Timeout	Configure\Edit\
	Register determines how long (in seconds) an originating modem waits	Line Dialer
	before abandoning a call when no answer tone is received.
	Enter a value from 1±255 seconds.
	Factory setting is 45 seconds.
S8	``,º Pause Time for the Dial Modifier	Configure\Edit\
	Register determines how long (in seconds) the modem pauses when it	Line Dialer
	encounters a comma (,) in the Dial command string.
	Enter a value from 0±255 seconds.
	Factory setting is 2 seconds.
S10	No Carrier Disconnect	Configure\Edit\
	Register determines how long (in tenths of seconds) the modem allows the	Line Dialer
	carrier signal to be off before disconnecting the call.
	Enter a value from 0±254 in 0.1 second increments. (A value of 255
	disables this register.)
	Factory setting is 20 (2 seconds).
S12	Escape Guard Time	Configure\Edit\
	Register sets the value (in 20-millisecond increments) for the required	DTE Dialer
	pause before and after the escape sequence is issued. The guard time
	prevents the modem from interpreting data as the escape sequence
	characters.
	Enter a value from 0±255 in 20-millisecond increments. For example, the
	factory setting of 50 equals 1000 milliseconds or one second.
	Factory setting is 50 (1 second).

3980-A2-GB30-20 November 1996 13-15