Lexmark 279 manual Understanding the printer menus 113, Alarms, Timeouts

Understanding the printer menus		113
	Use	To
	Alarms	Set an alarm to sound when operator intervention is required.
	Alarm Control	For each alarm type, select from the following options:
	Cartridge Alarm	Off
		Single
		Continuous
		Notes:
		• Single is the factory default setting for Alarm Control. This
		sounds several short beeps.
		• Off is the factory default setting for Cartridge Alarm.
		• Continuous repeats several short beeps at a regular interval.
	Timeouts	Set the amount of time the printer waits after a job is printed before
	Sleep Mode	it goes into a reduced power state.
	Disabled	Notes:
	1–120	• 20 minutes is the factory default setting.
		• Disabled appears only when Energy Conserve is set to Off.
		• Lower settings conserve more energy, but may require
		longer warm‑up times.
		• Select a high setting if the printer is in constant use. Under
		most circumstances, this keeps the printer ready to print.
	Timeouts	Print a job while the display is off.
	Print with Display Off	Note: Display on when printing is the factory default setting.
	Allow printing with display off
	Display on when printing
	Timeouts	Set the amount of time the printer waits before it enters Hibernate
	Hibernate Timeout	mode.
	Disabled	Note: 3 days is the factory default setting.
	20 minutes
	1–3 hours
	6 hours
	1–3 days
	1–2 weeks
	1 month
	Timeouts	Set the printer to hibernate mode when there is an active Ethernet
	Hibernate Timeout on Connection	connection.
	Hibernate	Note: Hibernate is the factory default setting.
	Do Not Hibernate
	Timeouts	Set the amount of time before the display returns to a Ready state.
	Screen Timeout	Note: 30 seconds is the factory default setting.
	15–300