Lexmark 279 manual TCP/IP menu, Understanding the printer menus 105

Understanding the printer menus		105
	Use	To
	View Card Status	View the connection status of the wireless network adapter.
	Connected
	Disconnected
	View Card Speed	View the speed of an active wireless network adapter.
	Network Address	View the network addresses.
	UAA
	LAA
	Job Timeout	Set the amount of time it takes for a network print job to be canceled.
	0, 10–225 seconds	Notes:
		• “90 seconds” is the factory default setting.
		• A setting value of 0 disables the timeout.
		• If a value between 1 and 9 is selected, then Invalid appears on the
		display, and the value is not saved.
	Banner Page	Allow the printer to print a banner page.
	Off	Note: Off is the factory default setting.
	On

TCP/IP menu

To access the menu, navigate to either of the following:

•Network/Ports > Standard Network > Standard Network Setup > TCP/IP

•Network/Ports > Network [x] > Network [x] Setup > TCP/IP

Note: This menu is available only in network printers or printers attached to print servers.

Use	To
Set Hostname	Set the current TCP/IP host name.
	Note: This can be changed only from the Embedded Web Server.
IP Address	View or change the current TCP/IP address.
	Note: Manually setting the IP address sets the Enable DHCP and Enable Auto IP
	settings to Off. It also sets Enable BOOTP and Enable RARP to Off on systems that
	support BOOTP and RARP.
Netmask	View or change the current TCP/IP netmask.
Gateway	View or change the current TCP/IP gateway.
Enable DHCP	Specify the DHCP address and parameter assignment.
On	Note: On is the factory default setting.
Off
Enable RARP	Specify the RARP address assignment setting.
On	Note: Off is the factory default setting.
Off