Lexmark 279 manual Network Card menu, Understanding the printer menus 104, UseTo

Understanding the printer menus		104
	Use	To
	Network Buffer	Set the size of the network input buffer.
	Auto	Notes:
	3KB to [maximum size allowed]
		• Auto is the factory default setting.
		• The value can be changed in 1KB increments.
		• The maximum size allowed depends on the amount of memory in the printer,
		the size of the other link buffers, and whether Resource Save is set to On or
		Off.
		• To increase the maximum size range for the Network Buffer, disable or
		reduce the size of the parallel, serial, and USB buffers.
		• Changing this setting from the printer control panel, and then exiting the
		menus causes the printer to restart. The menu selection is then updated.
	Mac Binary PS	Set the printer to process Macintosh binary PostScript print jobs.
	On	Notes:
	Off
		• Auto is the factory default setting.
	Auto
		• Off filters print jobs using the standard protocol.
		• On processes raw binary PostScript print jobs.
	Standard Network Setup or	Display and set the printer network settings.
	Network [x] Setup	Note: The Wireless menu appears only when the printer is connected to a wireless
	Reports
		network.
	Network Card
	TCP/IP
	IPv6
	Wireless
	AppleTalk

Reports menu

To access the menu, navigate to either of the following:

•Network/Ports > Standard Network > Standard Network Setup > Reports

•Network/Ports > Network [x] > Network [x] Setup > Reports

UseTo

Print Setup Page Print a report containing information about the network printer settings, such as the TCP/IP address.

Network Card menu

To access the menu, navigate to either of the following:

•Network/Ports > Standard Network > Standard Network Setup > Network Card

•Network/Ports > Network [x] > Network [x] Setup > Network Card