Lexmark 279 manual

Tips on using card stock

Card stock is heavy, single‑ply specialty media. Many of its variable characteristics, such as moisture content, thickness, and texture, can significantly impact print quality. Print samples on the card stock being considered for use before buying large quantities.

Portrait orientation is recommended, especially when printing bar codes.

•

– The labels can withstand temperatures up to 240°C (464°F) without sealing, excessive curling, wrinkling, or releasing hazardous emissions.

– Label adhesives, face sheet (printable stock), and topcoats can withstand up to 172‑kPa (25‑psi) pressure without delaminating, oozing around the edges, or releasing hazardous fumes.

• Do not use labels with slick backing material.

• Use full label sheets. Partial sheets may cause labels to peel off during printing, resulting in a jam. Partial sheets also contaminate the printer and the cartridge with adhesive, and could void the printer and toner cartridge warranties.

• Do not use labels with exposed adhesive.

• Do not print within 1 mm (0.04 inch) of the edge of the label, of the perforations, or between die‑cuts of the label.

• Make sure the adhesive backing does not reach to the edge of the sheet. Zone coating of the adhesive should be at least 1 mm (0.04 inch) away from edges. Adhesive material contaminates the printer and could void the warranty.

• If zone coating of the adhesive is not possible, then remove a 2‑mm (0.08‑inch) strip on the leading and driver edge, and then use a non‑oozing adhesive.

Use labels designed specifically for laser printers. Check with the manufacturer or vendor to verify that:

•

Note: A combination of high humidity (over 60%) and high printing temperature may wrinkle or seal envelopes.

Tips on using labels

Print samples on the labels being considered for use before buying large quantities.

Note: Use only paper label sheets. Vinyl, pharmacy, and two‑sided labels are not supported.

For more information on label printing, characteristics, and design, see the Card Stock & Label Guide available at http://support.lexmark.com.

When printing on labels:

Adjust the width guides to fit the width of the envelopes.

•

Paper and specialty media guide 48

•To optimize performance and minimize jams, do not use envelopes that:

–Have excessive curl or twist

–Are stuck together or damaged in any way

–Have windows, holes, perforations, cutouts, or embossing

–Have metal clasps, string ties, or folding bars

–Have an interlocking design

–Have postage stamps attached

–Have any exposed adhesive when the flap is in the sealed or closed position

–Have bent corners

–Have rough, cockle, or laid finishes