3Com OfficeConnect Remote 812 manual set ipx network networkname, sapupdateinterval number

B-30APPENDIX B: CLI COMMAND DESCRIPTION

rip_flags	Flags indicate at which level a RIP instance is disabled or
	configured. Choices are:
	METRICS - Specifies how to increment metrics using
	RFC1058.
	SEND_REQUEST - Sends a RIP request for routing information
	when an interface first comes up.
Router_id	The IP station address of the ip router.

set ipx network <network_name>

delay_ticks [number] diagnostics [DISABLE ENABLE] maximum_learning_retries [number] netbios [ENABLE DISABLE] netbios_name_cache [DISABLE ENABLE] netbios_cache_timer [seconds] netbios_max_hops [number] packet_maximum_size [number]

rip [BOTH DISABLE LISTEN RESPOND_ONLY SEND] rip_age_multiplier [number]

rip_packet_size [number]

rip_update_interval [number]

sap [BOTH DISABLE LISTEN RESPOND_ONLY SEND] sap_age_multiplier [number]

sap_packet_size [number]

sap_nearest_replies [ON OFF]

￿sap_update_interval [number]

Sets parameters for the specified IPX network.

Parameter	Description
<network_name>	Designation of the IPX network. Maximum size is 32 characters.
delay_ticks	Interval in number of ticks it takes to reach this IPX network.
diagnostics	Whether or not to send diagnostic packets to this IPX network.
maximum_learning_	Number of times this network will re-send packets to learn its directly
retries	connected neighbors.
netbios	Whether to support NetBIOS on dial-out IPX networks.
netbios_name_cache	Whether or not to cache a list of the other NetBIOS systems on this
	IPX network.
netbios_cache_timer	How long a NetBIOS system will be kept in the cache.
netbios_max_hops	Maximum number of hops this network will make to locate a
	NetBIOS system.